Warmington Studio Oven Installation Instructions Manual - page 10
21 February 2017
All Dimension are in mm………….Copyright ©
10
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
CLEANING OUT SIDE CHANNELS / SOOT & DEPOSITS
STEP 1
Step1 :
Ensure Fire is not going & Remove 2X Inspection Caps from the Top
Plate as Shown in Diagram
STEP 2
Step 2 :
With both doors closed Sweep out 2X side Channels with a
100mm dia chimney sweeping Brush or equivalent too , till
Channels are clear of any soot etc .
STEP 3
Step 3 :
Open Bottom Oven Door & Slide out Ashpan at the Bottom , then empty
ash etc & place back in position & close door .
STEP 4
Step 4 :
Replace Caps back in Position & the Fire is ready to use .
CHIMNEY SWEEPING
Step1 :
Remove Baffle from top Firebox , as shown in diagram A , Close Both
Doors to stop any Soot coming into the room , as Shown in Diagram
B . Also Open the Oven Damper Control on the R/H Top Side of the
Fire , as Shown in Diagram C .
STEP 1
A
C
B
STEP 2
Step 2 :
Remove ADD Cowl on Roof as Shown in Diagram A & Sweep with suitable
sized Chimney Sweeping Brush to Flue Diameter from Top Down & when
finished , replace ADD Cowl as Shown in Diagram B .
Once Flue is Swept , Clean out Ash & Soot from the Firebox & Replace Baf-
fle Plate as Shown in Diagram C to Complete Chimney Sweep .
A
B