Installation a n d o p e r at i n g instructions 151211-24 ps 45 classic 5055.5313 contact your local building or fi re officials regarding permits and any information on installation and inspection requirements in your area. Tested and listed to astm 1509-04, can/ulc s627 and ul 1482 important: the...
Pellet stoves 2 ps45 classic 151211-24 please read this entire owner’s manual before installing or operating your warmland pellet stove. Introduction ................................................. 3 specifi cations ............................................. 3 listing information .................
Pellet stoves 3 ps45 classic 151211-24 introduction operation: for proper and safe operation, the door and ash drawer must be kept closed to prevent fume spillage when the unit is in operation. The auger will not operate when they are open. Check all gaskets on the door, ash pan and hopper lid and r...
Pellet stoves 4 ps45 classic 151211-24 caution: unit is hot while in operation. Parts of the appliance, especially the external surfaces, will be hot to touch when in operation. Keep children, clothing and furniture away. Contact may cause skin burns . Flammable liquids: never use gasoline, gasoline...
Pellet stoves 5 ps45 classic 151211-24 caution: it is important to select and use only fuel that is dry and free of dirt or other impurities such as high salt content. "dirty" fuel will adversely affect the operation and performance of the unit and will void the warranty. We recommend the use of pel...
Pellet stoves 6 ps45 classic 151211-24 installation before you begin please read and carefully follow all of the installation and operating instructions found in this manual. Please pay special attention to the safety instructions provided in this manual. It is recommended that you have this applian...
Pellet stoves 7 ps45 classic 151211-24 note: install vent a t c l e a r a n c e s s p e c i f i e d b y t h e vent manufacturer clearances to combustibles clearances: front 48” (1.2m) side 6" (155mm) back 3” (76mm) the center of the fl ue is 16-1/2” above the surface upon which the stove rests. Impo...
Pellet stoves 8 ps45 classic 151211-24 fig. #4 m k i a v g g h a j v g a b c a v v a v b f b l v e v v v d air supply inlet vent terminal gas meter fixed closed fixed closed open- able open- able area where terminal is not permitted vent terminal minimum clearances all clearances are minimums a= *12...
Pellet stoves 9 ps45 classic 151211-24 45 90 vent termination requirement 1. Do not terminate the vent in any enclosed or semi-enclosed areas such as a carport, garage, attic, crawlspace, narrow walkway, closely fenced area, under an enclosed sundeck or porch, or any location that can build up a con...
Pellet stoves 10 ps45 classic 151211-24 venting this heater is approved for venting with any 3" or 4" type pl and type l pellet vent pipe listed to ul 641 and ulc s609. Stainless steel single wall pipe can only be used as a liner inside a masonry or approved wood burning chimney system on this pelle...
Pellet stoves 11 ps45 classic 151211-24 chimney recommended chimney connector recommended the chimney may incorporate an offset. To do this safely, all sections of listed connector, offset elbows and chimney section must be screwed to- gether by at least three sheet metal screws per joint. The chimn...
Pellet stoves 12 ps45 classic 151211-24 thermostat installation the warmland ps45 classic stove can be operated manually or by a thermostat. The stove comes from the factory in the manual mode. To operate in the two "thermostat" modes a low voltage thermostat must be installed. Consult dealer for ap...
Pellet stoves 13 ps45 classic 151211-24 thermostat operation once installed, the thermostat can control the operation of the stove. Use a low voltage/millivolt thermostat. See page 12 for installation instructions. Important : when connected to a thermostat, it is necessary to push the ignite button...
Pellet stoves 14 ps45 classic 151211-24 inspection /cleaning weekly monthly yearly ash pan - leg model x or every 15 bags of fuel burned burn-pot x or every 5 bags of fuel burned burn-pot liner x or more frequently depending on fuel quality blower - convection x or more frequently if pets present bl...
Pellet stoves 15 ps45 classic 151211-24 lift out the stainless steel liner by pulling the burn-pot assembly towards you, then lift up. Disengage the burn-pot from the inlet tubes and remove. Empty the ash from the burn-pot and re-install. Scrape the bottom and sides of the pot with a screwdriver to ...
Pellet stoves 16 ps45 classic 151211-24 cleaning the flue gas passages cleaning the fl ue gas passage should be done at least once a year or every one to two tons of pellets used.(50-100 bags) burning high ash pellets may require this cleaning to be done more often. Clean this passage only when the ...
Pellet stoves 17 ps45 classic 151211-24 cleaning the combustion blower: to clean the combustion blower, unplug the stove, remove the left cabinet side. Loosen but do not remove the six screws (fig.#18) with an 1/4” nut driver or socket. Rotate the motor counter-clockwise. The motor can now be pulled...
Pellet stoves 18 ps45 classic 151211-24 component information the following is a list of other components and their functions. Igniter the warmland ps45 stove comes equipped with an automatic igniter for lighting the fuel when the stove is in the lighting mode. The igniter superheats air that is pul...
Pellet stoves 19 ps45 classic 151211-24 wiring diagram 5050.838 - a 010210 ps 45 wiring.
Pellet stoves 20 ps45 classic 151211-24 components list item qty. Part number description 1 1 ps45.7416xxx ps45 classic ashlip 2 1 dr31.???? Door assembly a 1 psrp.7340 burn pot/mixer assembly 3a 1 ps45.7341wld burn-pot liner 3b 1 ps45.7340wld burn-pot 4 1 ps45.7345weld burn-pot liner mixer 5 1 ps45...
Pellet stoves 21 ps45 classic 151211-24 a a b b components list a b.
Pellet stoves 22 ps45 classic 151211-24.
Pellet stoves 23 ps45 classic 151211-24 rating label.
Pacific energy fireplace products ltd. Www.Pacifi cenergy.Net 2975 allenby rd., duncan, bc v9l 6v8 technical support: 250-748-1184.
