Warmland PS45 series A Nstallation And Operating Instructions

Summary of PS45 series A

  • Page 1

    Installation a n d o p e r at i n g instructions 041113-24 ps 45b 5055.5311 contact your local building or fi re officials regarding permits and any information on installation and inspection requirements in your area. Tested and listed to astm 1509-04, can/ulc s627 and ul 1482 important: these inst...

  • Page 2: Contents

    Pellet stoves 2 ps45b 041113-24 please read this entire owner’s manual before installing or operating your warmland pellet stove. Contents introduction ................................................. 3 specifi cations ............................................. 3 listing information ...............

  • Page 3

    Pellet stoves 3 ps45b 041113-24 introduction operation: for proper and safe operation, the door and ash drawer must be kept closed to prevent fume spillage when the unit is in operation. The auger will not operate when they are open. Check all gaskets on the door, ash pan and hopper and replace when...

  • Page 4

    Pellet stoves 4 ps45b 041113-24 caution: unit hot while in operation. Parts of the appliance, especially the external surfaces, will be hot to touch when in operation. Keep children, clothing and furniture away. Contact may cause skin burns . Flammable liquids: never use gasoline, gasoline-type lant...

  • Page 5

    Pellet stoves 5 ps45b 041113-24 caution: it is important to select and use only fuel that is dry and free of dirt or other impurities such as high salt content. "dirty" fuel will adversely affect the operation and performance of the unit and will void the warranty. We recommend the use of pellets th...

  • Page 6

    Pellet stoves 6 ps45b 041113-24 installation before you begin please read and carefully follow all of the installation and operating instructions found in this manual. Please pay special attention to the safety instructions provided in this manual. It is recommended that you have this appliance inst...

  • Page 7

    Pellet stoves 7 ps45b 041113-24 note: install vent a t c l e a r a n c e s s p e c i f i e d b y t h e vent manufacturer clearances to combustibles clearances front 48” (1.2m) side 6" (155mm) back 3” (76mm) the center of the fl ue is 18-5/8” above the surface upon which the stove rests. Important in...

  • Page 8

    Pellet stoves 8 ps45b 041113-24 fig. #5 m m m m v m m m m m v m m b m m v v m v b m b l v e v v v m air supply inlet vent terminal gas meter fixed closed fixed closed open- able open- able area where terminal is not permitted vent terminal minimum clearances all clearances are minimums a= *12 inches...

  • Page 9

    Pellet stoves 9 ps45b 041113-24 45 90 vent termination requirement 1. Do not terminate the vent in any enclosed or semi-enclosed areas such as a carport, garage, attic, crawlspace, narrow walkway, closely fenced area, under an enclosed sun deck or porch, or any location that can build up a concentra...

  • Page 10

    Pellet stoves 10 ps45b 041113-24 venting this heater is approved for venting with any 3" or 4" type pl and type l pellet vent pipe listed to ul 641 and ulc s609. Stainless steel single wall pipe can only be used as a liner inside a masonry or approved wood burning chimney system on this pellet stove...

  • Page 11

    Pellet stoves 11 ps45b 041113-24 chimney recommended chimney connector recommended the chimney may incorporate an offset. To do this safely, all sections of listed connector, offset elbows and chimney section must be screwed to- gether by at least three sheet metal screws per joint. The chimney must...

  • Page 12

    Pellet stoves 12 ps45b 041113-24 thermostat installation the warmland ps45 stove can be operated manually or by a thermostat. The stove comes from the factory in the manual mode. To operate in the two "thermostat" modes a low voltage thermostat must be installed. To install the thermostat: 1) unplug...

  • Page 13

    Pellet stoves 13 ps45b 041113-24 thermostat operation once installed, the thermostat can control the operation of the stove. Use a low voltage/millivolt thermostat. See page 12 for installation instructions. Important : when connected to a thermostat, it is necessary to push the ignite button for th...

  • Page 14

    Pellet stoves 14 ps45b 041113-24 inspection /cleaning weekly monthly yearly ash pan - pedestal x or every 30 bags of fuel burned ash pan - leg model x or every 15 bags of fuel burned burn-pot x or every 5 bags of fuel burned burn-pot liner x or more frequently depending on fuel quality blower - conv...

  • Page 15

    Pellet stoves 15 ps45b 041113-24 fig. #12 lift out the stainless steel liner by pulling the burn-pot assembly towards you, then lift up. Disengage the burn-pot from the inlet tubes and remove. Empty the ash from the burn-pot and re-install. Scrape the bottom and sides of the pot with a screwdriver t...

  • Page 16

    Pellet stoves 16 ps45b 041113-24 cleaning the flue gas passages cleaning the fl ue gas passage should be done at least once a year or every one to two tons of pellets used.(50-100 bags) burning high ash pellets may require this cleaning to be done more often. Clean this passage only when the stove a...

  • Page 17

    Pellet stoves 17 ps45b 041113-24 fig. #19 cleaning the combustion blower to clean the combustion blower, unplug the stove, remove the left cabinet side. Loosen (do not remove) the six screws (fig.#19) with a 1/4” nut driver or socket. Rotate the motor counter-clockwise. The motor can now be pulled f...

  • Page 18

    Pellet stoves 18 ps45b 041113-24 component information the following is a list of other components and their functions. Igniter the warmland ps45 stove comes equipped with an automatic igniter for lighting the fuel when the stove is in the lighting mode. (fig. #21) the igniter superheats air that is...

  • Page 19

    Pellet stoves 19 ps45b 041113-24 wiring diagram 5050.838 - a 010210 ps 45 wiring.

  • Page 20

    Pellet stoves 20 ps45b 041113-24 components list item qty. Part number description 1 1 5037.475 cast ash lip, pellet stove 2 1 door c 1 psrp.7340 burn-pot/mixer assembly 3a 1 ps45.7340wld burn-pot 3b 1 ps45.7341wld burn-pot liner 4 1 ps45.7345weld burn-pot mixer 5 1 ps45.7343wld burn-pot grate 6 2 5...

  • Page 21

    Pellet stoves 21 ps45b 041113-24 a b c d.

  • Page 22

    Pellet stoves 22 ps45b 041113-24 a b a b a b.

  • Page 23

    Pellet stoves 23 ps45b 041113-24 model ps45 series a classic ped. Leg tested to/ testÉ selon la norme: astm e 1509-04 / ulc s627-00 input / puissance : 12,000 - 45,000 btu/hr electrical/electrique: 120v a/c, 4.3amp, 60hz install and use only in accordance with pacifi c energy installation and operat...

  • Page 24

    Pacific energy fireplace products ltd. Www.Pacifi cenergy.Net 2975 allenby rd., duncan, bc v9l 6v8 phone: 250-748-1184.