Warmly Yours Under Desk Heater User Manual - page 3
INSTALLATION AND OPERATIONAL INSTRUCTIONS
This appliance must be installed in accordance with the instructions
in this manual. Please read all instructions before installing and
operating the Under Desk Heater.
1. Clean the fl oor of any debris or sharp objects.
2. Lay the Under Desk Heater completely fl at on the fl oor with the
carpet side facing up.
3. Remove any excess cord from underneath the Heater before
connecting the power cord to the electrical outlet.
4. Plug the Heater into a standard 120V, 15A electrical outlet.
Note: If you notice a slight odor when fi rst using your Heater,
continue to use as instructed. The odor will dissipate over time.
5. Select the “on” position located on the rocker switch to turn
the Under Desk Heater on.
6. The mat will be warm to the touch within 5 minutes. Allow
approximately 30 minutes for your Heater to reach optimal
temperature.
7. Turn your Under Desk Heater “off” when not in use.
Note: If the mat does not heat up within 5 – 10 minutes, the
Appliance Leakage Current Interrupter (ALCI) may be tripped,
preventing your mat from heating up. (Diagram A). To ensure that
the mat is heating, switch to the “on” position and press the white
button. The red button will pop up. Then, press the red button to
reset the ALCI and begin the heating process.
2