Warmtech underfloor heating Installation Instructions Manual - page 19
Installation Step 10 – Controller Connection
Grout the floor as soon as possible as per the
adhesive manufacturer’s instructions (Extra
care should be taken when cleaning
between the tiles prior to grouting).
Do not switch on the heater until the tile
adhesive has fully cured (7-10 days).
Once the heater and controller have been installed and the tile adhesive has
cured, all electrical circuit wiring and connection of this appliance must be
undertaken in accordance with current electrical standards and practices.
Note:
Your Warmtech heating element has been classified as an electrical
appliance.
You are therefore not required to be an electrician to install (lay out) the
element. All electrical connections including the connection of the
controller must be undertaken by a licensed electrician.
Means shall be provided to ensure all-pole disconnection from supply.
Ensure all electrical supply circuits to the heating elements are protected
via a RCD (Residual Current Device) protected circuit.
If you have upgraded your controller, then please refer directly to that
controller for wiring details.
Operation
Once the heater and controller have been installed and the tile adhesive has
cured, the heater can be switched on. Initial heat up time will vary depending
upon the age of the floor, floor type (concrete or timber), time of year,
thermal characteristics and insulation of your sub floor. These heat up times
will improve with increased usage.
Ensure your Electrician reads through the instructions as supplied with the
thermostat before connecting the thermostat.
19