Installation manual: underfloor heating mat - type pvc technical helpline 0845 345 2288 important read this manual before attempting to install the heater. Incorrect installation could damage the heater and will invalidate your warranty. Complete and submit your warranty form online at www.Warmup.Co...
2 contents contents do’s and don’ts selecting the correct heater what you need for installation floor coverings safety - electrical considerations subfloor preparation about the mat testing the mat sizing guide how you can modify the mat installation control card warranty 3 4 5 6 7 10 your warmup un...
Carefully read this instruction manual before commencing installation. Consult our helpline or a competent professional if you are unsure how to proceed. Ensure the system is tested before, during and after installation. Plan your mat layout and installation so that any drilling after tiling (e.G. F...
4 what you need for installation components included in your warmup pvc kit : • warmup pvc mat • installation manual additional components needed as part of your warmup heating installation: • a warmup® thermostat with floor sensor. Note: only warmup® thermostats should be used. • 30ma residual curr...
5 subfloor preparation 1 2 3 4 5 wooden subfloors • ensure adequate underfloor ventilation • existing floorboards need to be securely fixed and if necessary pre-levelled with a latex/cement self-levelling compound to give a flush fit for the subsequently applied wbp plywood (18mm) or an insulated ti...
Testing the mat sizing guide the heaters must be tested before, during and after tiling. We recommend the use of a digital multi-meter set to a range of 0-2 k ohms for testing. The resistance (ohms) of each mat should be measured. You should carry out the following tests and should expect the result...
7 how you can modify the mat in order to fit your mat into a specific area, it may be necessary to cut and turn the mat (examples below). Never cut the heating element. When cutting and flipping the mat take care not to cut or damage the heating cable. Turn turn flip flip cut & remove mat cut & remo...
Installing the mat step 1 - mark the subfloor ensure that the subfloor is of the same construction where you intend to lay the mat to ensure that the heater performs effectively. Warmup always recommend that insulation boards, such as warmup® insulation boards (10mm recommended), are used to improve...
Step 5 - install floor sensor place the floor sensor below the fibreglass mesh. The floor sensor must be installed centrally between the two runs of heating element and should extend a minimum of 150mm into the heated area. Secure the sensor to the floor using tape. Note: do not tape over the sensor...
Heater location _________________________ total wattage __________________________ place this card in a visible spot close to the consumer unit. Signed date company stamp/name caution radiant floor heating systems warming-risk of electric shock electric-wiring and heating panels contained below the ...
Terms and conditions apply models: pvc, pvcm, 2pvcm**r and ssmat heaters manufactured by warmup plc - the 10 year element of this guarantee does not extend to thermostats which are covered by separate guarantees. This guarantee does not affect your statutory rights. Safetynet tm installation guideli...
V2.0 03/15 the warmup word and associated logos are trade marks. © warmup plc. 2014 – regd. Tm nos. 1257724, 4409934, 4409926, 5265707. E & oe. Warmup plc 702 & 704 tudor estate abbey road london nw10 7uw web: www.Warmup.Co.Uk email: uk@warmup.Com tel: 0845 345 2288 fax: 0845 345 2299.
