Warmup underlaminate Installation Manual - Getting Started
2
Your Warmup® Underlaminate Foil Heater has been designed so that
installation is quick and straight forward, but with all electrical systems,
certain procedures must be strictly followed.
Please check the sizing guide at the back of this manual to ensure that
you have the correct heater(s) for the area you wish to heat.
Getting Started
Before installing your new Warmup
®
underlaminate foil heating mats, be sure you have the following
additional parts:
Electrical junction box – used as the connecting junction for the electrical supply cables of the
heating mats.
Control thermostat – allows you to control the temperature of the room.
Residual Current Device - Consult your electrician regarding the applicable RCD.
Hard insulation materials – used as heat insulator under the foil heating mats in installations with
concrete subfloors to provide more efficient heating. The material comes in plates, usually made from
foamed Polyurethane or Polystyrene and should have Compressive strength of more than 28PSI
(2Kg/cm
2
). An example of this is the Warmup
®
Insulation Board.
Soft insulation material – any soft insulation suitable for wood or laminate. which has a fire rating
of B2 or greater.