WarmYourFloor SunTouch P-3285 Instructions

SunTouch P-3285 DualTemp Digital Outdoor Instructions 

24v for use with CP ContactorPro Panels (CP-50/100/200) 

To enter the parameter menu, press and hold the OK button for 5 seconds. 

•  Use the +/- keys to select the installation parameter to be adjusted.  

• Press 

OK to toggle the parameter setting or to edit its value.   When the value begins to blink, use the 

+/- keys to adjust its value.   Press OK to select the adjusted value. 

•  Toggle to “End” and press OK to exit the installation parameter menu. 

• Parameters 

(Only Bold apply to Outdoor Patio Heating)

•  J0: °C/°F Temperature display section. 

• 

J1: Hot

/Cold regulation mode. Select Hot for Heating, Cold for cooling. 

•  Cy: Proportional Integral regulation time cycle, value in minutes (default: 15 minute cycle). 

•  bp: Proportional Integral regulation band amplitude value in degrees °C/°F (default: 2.0°C/3.6°F). 

• 

J4

: NO/

NC

 Normally Open or Normally Close actuator selection. 

ƒ  NC: If using an isolation relay and/or a relay box. 

ƒ  NO: if connecting to a Watts Zone Valve control. 

•  J5: Select PMP (Pump Maintenance Program) to perform a 1 minute exercise every day. 

• 

J6:

 Air: Air (room) setpoint. Displays air temperature with floor low (FL) and high (FH) limits. 

ƒ  Flr:  Floor (external sensor) setpoint. Displays floor temperature 

without floor low/high limits. Air temperature is not a control 

boundary. 

ΠAir temp is not used because the T-stat is mounted INSIDE and the 

area to be monitored is OUTSIDE and monitored with Floor Sensor 

Only 

•  J7: rEG (proportional Integral) or HYs (0.3°C Hysteresis) regulation type selection. 

•  Cp: Proportional Integral regulation temperature compensation value in °C/°F 

• (default: 

2.0°C/3.6°F). 

•  Ao: Air Sensor offset adjustment (default: no offset), display measure air sensor value. 

•  Fo: Floor sensor offset adjustment (default: no offset), display measure floor 

• sensor 

value. 

•  FL: Floor temperature LOW limitation (default: 5°C/41°F), effective only if floor 

•  sensor present and set J6 to Air. 

•  FH: Floor temperature HIGH limitation (default: 28°C/82°F), effective only if floor 

•  sensor present and set J6 to Air. 

•  CLr: Press OK to reset to factory defaults. 

•  End: Press OK to exit installation parameters. 

23055 Alcalde Drive, Laguna Hills, CA   92653 

Toll Free 866 – 558 – 3369 ● Fax 866 – 558 – 2010 

www.WarmYourFloor.com

CustomerCare@warmyourfloor.com