1. DL manuals
  2. Warsanis
  3. Sound Card
  4. 1401FM
  5. Quick Installation And Setup Manual

Warsanis 1401FM Quick Installation And Setup Manual

Manual is about: MODULATION PROCESSOR

Summary of 1401FM

  • Page 1

    Warsanis 1401fm user manual quick installation and setup manual warsanis modulation processor march 2001 model 1401fm wijde wade 5 3439 np nieuwegein the netherlands tel. 31 (0)30 2322209 fax. 31 (0)30 2304959 email. Info@warsanis.Nl http://www.Warsanis.Nl 1.

  • Page 2

    Warsanis 1401fm user manual manual rev.2.2 part number: m1401fm0397 8/2001 warsanis productions. 2.

  • Page 3

    Warsanis 1401fm user manual table of contents p age contents 1 table of contents 2 table of contents, continued 3 warranty introduction 4,5 short description of the warsanis 1401fm 6 installation general installation in the studio installation at the transmitter site 7 changing the input sensitivity...

  • Page 4

    Warsanis 1401fm user manual table of contents, continued p age contents 13 the warsanis 1401fm in harmony with other equipment mic processing leveler other effect equipment stereo enhancers equalizers audio exciters bass enhancers 14 test and alignment procedures power-up test input stage test phase...

  • Page 5

    Warsanis 1401fm user manual warranty warsanis productions warrants its products to be free from any defects in workmanship for a period of one year.This warranty will not be void if the user modifies a warsanis product. However, broken wires, broken pc board circuit traces, burned areas and broken c...

  • Page 6

    Warsanis 1401fm user manual short description of the 1401fm the phase scrambler (rotator) makes peaks more symmetrical to fully benefit the symmetrical peak overload characteristics of the fm medium. Voice and some music can contain asymmetrical waveforms that can overload the processing circuit. By...

  • Page 7

    Warsanis 1401fm user manual the stereo generator (option) uses a digitally controlled circuit to produce a high quality composite signal. The stereo generator has two outputs both with independ- ent output amplifiers and level controls. A sca (subcarrier) input is available for rds and a 19khz (ttl)...

  • Page 8

    Warsanis 1401fm user manual installation general we suggest leaving one rack space vacant between the units. When several units are in a common rack, we recommend using one common power supply-strip to minimize hum and ground loop problems. Installation in the studio the warsanis 1401fm should alway...

  • Page 9

    Warsanis 1401fm user manual changing the input sensitivity (skip this step if you want an input sensitivity of -10 to +10dbu) the warsanis 1401fm is shipped with the input sensitivity set to -10 to +10dbu. This is the most common setting for professional broadcast equipment. Move the four jumpers (j...

  • Page 10

    Warsanis 1401fm user manual changing the composite output impedance the warsanis 1401fm is shipped with a composite output impedance op 0ohm. This is the common impedance for most situations. If a 75ohm output impedance is required you have to change two jumpers on the stereo generator pcb. Make sur...

  • Page 11

    Warsanis 1401fm user manual setup & operation the warsanis 1401fm is very easy to a setup. You will need 15 to 30 minutes to set up the entire system. Installing the 1401fm preparation make sure your transmitter or stl link has a flat input and that all pre-em- phasis, low and highpass filters and t...

  • Page 12

    Warsanis 1401fm user manual using sca most countries will not require adjustment of the input level of the stereo generator. They allow you to generate sca signals on top of the mpx signal. This results in a higher devation than "75khz reading on your modulation monitor. If you have finished the lin...

  • Page 13

    Warsanis 1401fm user manual operation make sure the warsanis 1401fm bypass switch is switched to operate. The first stage of the setup is the agc. Use normal program material. Adjust the drive leveler to get approximately 4 to a maximum of 8 db gain reduction on the led bar of the leveler. Watch the...

  • Page 14

    Warsanis 1401fm user manual recommended settings format leve ler g/r* multi- band g/r* level er dens ity band 1 dens ity band 2 dens ity band 3 dens ity band 4 drive multi- band clip- ping drive loud- ness clippi ng install ation - 15 bypa ss - - - - -4 +4 classic al - 2 / 4 bypa ss slow slow slow s...

  • Page 15

    Warsanis 1401fm user manual the warsanis 1401fm in harmony with other equipment mic processing most stations use mic processing for its announcers. Be sure to tune the warsanis 1401fm to your desired sound before tweaking the mic processors. Use only a few db of gain reduction on your mic processor....

  • Page 16

    Warsanis 1401fm user manual test and alignment procedures thanks to the design of the warsanis 1401fm the unit does not have any user alignment points. These tests schould be carried out off air. Power-up test a. Apply power and immediately check for overheating of the regulators on the power board....

  • Page 17

    Warsanis 1401fm user manual be very care full, do not touch any other pins than those shown below!! A. Leveler and system switch: operate. B. Feed program material or white noise to the unit. Low band check (front pcb board2) check audio on pin 1 and 7 at u5 mid low band check (front pcb board2) che...

  • Page 18

    Warsanis 1401fm user manual loudness clipping test no audio is necessary to preform this test. A. Locate the loudness clipper diodes on the output board. These diodes are located above and below u9. The loudness clipping control does not have any affect on the dc voltage of the diodes. B. Connect yo...

  • Page 19

    Warsanis 1401fm user manual troubleshooting determine if the problem is caused by the warsanis 1401fm and not by other equipment. Lost of modulation * check the connection to and from the warsanis 1401fm. * if this is not the problem disconnect the unit from your audio chain. Test the unit again. C ...

  • Page 20

    Warsanis 1401fm user manual * locate the multiband clipper diodes on the output board. * feed audio into the unit. * check on audio at the left side of the left row of diodes (d1, 3, 9, 11, 13, 15 and 17). For the other channel, check the right side of the right row of diodes (d2, 4, 10, 12, 14, 16,...

  • Page 21

    Warsanis 1401fm user manual technical specifications: general: total harmonic distortion (thd): signal to noise: > 60 db (70 db typical). Audio input: >20k balanced. Input sensitivity: -20 dbm or +10 dbm (jumper selectable). Input connectors: xlr. Audio output: balanced. Output level: adjustable up ...

  • Page 22

    Warsanis 1401fm user manual peak modulation control: within " 2% typical. Low pass filter: 9th order elliptical phase linear. Pilot protection: >60 db. Upper composite protection: >65 db. Phase / overshoot filters: compensate the overshoots and phase difference created by crossover networks and low ...

  • Page 23

    Warsanis 1401fm user manual stereo generator specifications stand-a-lone performance - frequency response: 0.5db, 30hz-15khz. - separation: >55db, 400hz. - noise (50 microseconds de-emphasized, 100% modulation): >75db. - total harmonic distortion: - crosstalk-linear (referenced to 100% modulation): ...