Warwick FRAMUS Owner's Manual - Front Control Panel
8
FRONT CONTROL PANEL
INPUT
Socket for the connection of a guitar
Clean Channel:
VOLUME
Rotary control to set input sensitivity and volume level. *TIP*
BASS
Rotary control to set the level of low frequencies in the preamp
TREBLE
Rotary control to set the level of high frequencies in the preamp
CLEAN BRIGHT
Switch to boost high frequencies
LEAD BUTTON
Activates Lead Channel and deactivates the Clean channel.
(LED lights up red when activated)
Lead Channel:
GAIN
Rotary control to set the input sensitivity
BASS
Rotary control to set the level of low frequencies in the preamp
MIDDLE
Rotary control to set the level of mid frequencies in the preamp
TREBLE
Rotary control to set the level of high frequencies in the preamp
PRESENCE
Rotary control to set the level of high frequencies in the power amplifier
VOLUME
Rotary control to set the volume level
LEAD BOOST switch to boost the input sensitivity (GAIN) by 10dB. The input sensitivity can be adjusted with the trim pot
between V1 and V2 (see valve map)
*TIP*
Adjusting the volume and relation of the channels among each other should be done with the volume control of the Lead channel.
First set the desired input sensitivity of both channels by using the Volume control of the Clean channel and the Gain control of
the Lead channel. Compare the volume levels of the two channels and set the volume relations with the Master control of the
Lead channel.
THE FOLLOWING CONTROLS AFFECT ALL CHANNELS:
DEEP
switch boosts the level of low frequencies in the power amplifier.
MASTER 2 BUTTON
Activates the MASTER 2 control and simultaneously deactivates the MASTER 1 control
(LED lights up red)
MASTER 1
Control to set overall volume level 1
MASTER 2
Control to set overall volume level 2
REVERB
Control to set the level of the integrated spring reverb.
STANDBY
Switches the power amplifier to Standby mode
POWER
Switches the device On and Off