Warwick RockBass Series Manual - 3) Nut / Bridge
8
3) Nut / Bridge
Nut:
Just A Nut III is the standard on RockBass
®
bass
guitars since 2008, manufactured using high-tech
material with the best tonal characteristics, fine adjus-
tability and stability.
Use the included 1.5 mm Hex Key wrench to adjust
the string’s height at the nut.
Bridge:
The Warwick 3-D Bridge features additional adjustments on the top of the floating bridge: Into-
nation, string spacing as well as individual string saddle height adjustment to accommodate the
fingerboard’s radius.
Tip:
Press down the string at the 3rd fret.
Check the distance between the first fret
and the string. It shouldn’t read more than
0.3 mm (0.01“), which equals the thickness
of a business card.
1
3
2
5
4
1. First loosen the locking screw (1) with the included 2.5 mm (0.1“) Hex Key wrench, the bridge is
now unlocked and can be adjusted with the adjustment screws (2).
2. To adjust the height of each individual string saddle as well as adjusting the string spacing, loosen
the locking screws (3) with the included 1.5 mm (0.06“) Hex Key wrench. The saddle can now be
moved sideways to the left or right to obtain the desired string spacing.
3. In this step you can also adjust the height of each individual string saddle, using the 1.5 mm
(0.06“) Hex Key wrench on the height adjustment screws (4). Ideally the strings heights follow the
fingerboard’s radius.
4. You can adjust the intonation screws (5) with a screwdriver. Turning the screws clockwise will
increase the string’s length between bridge and nut; turning them counterclockwise will decrease
the string’s length.
5. Once the setup is done, tighten the locking screws 1 and 3 to lock the bridge in place.