Summary of X-Treme 10.1
Page 1
Official warwick amp owner manual.
Page 3: English
English.
Page 4: English
English safety hints - read these instructions - keep these instructions - heed all warnings - follow these instructions caution: to reduce the risk of electrical shock, do not remove the cover. Or expose this appliance to rain or moisture. No user serviceable parts insi- de; refer serving to qualif...
Page 5: Recommendations
Recommendations the following recommendations are designed to ensure that the device always functions reliably: • never open the casing! To do so would expose you to the risk of an electric shock. Should repairs prove necessary, leave them to qualified service personnel. • avoid dust and high moistu...
Page 6: Englsih
Englsih protective circuits your new warwick amplifier is equipped with a series of circuits to prevent it from destruction in case of inadequate ope- rating conditions: power-up delay: when the unit is switched on, the speaker out sockets are activated with a slight delay to protect the loudspeaker...
Page 7: Tubepath
Tubepath front panel controls input socket to plug in a bass guitar. Low boost switch + led to boost low end. Bass control to cut or boost deep frequencies. Mid 1 control to cut or boost low-mid frequencies shift 1 switch + led to set the operating frequency of mid 1 mid 2 control to cut or boost hi...
Page 8: X-Treme
X-treme front panel controls input socket to plug in a bass guitar. Gain control + clip led to adjust the input level*. -10 db pad switch to set the range of the gain control. Use it with high output basses. Compressor switch + 2-colored on/compress led to compress the signal. In position up the com...
Page 9: Rear Panel Controls
Rear panel controls fuse: fuse: 115 115 v ~ 15 ~ 15 a a 230 v 230 v ~ 8 a x-treme mains in ac ac terminal with integrated fuse compartment for connection to the mains power supply. Ground lift switch isolates the earth connection from the ground of signal. Should several devices be simultane- ously ...
Page 10
Technical data tubepath 5.1 / 10.1 input 25 mv tubes 2x ecc 83 / 1x el84 (2nd stage) poweramp fan cooled (temperature controlled) gain green led indicates the optimal level for clean sound orange led indicates the tube saturation for crunch sound. Equalizer low ±12db @ 80hz low mid 1 ±10db @ 180hz l...
Page 11: Connect Speakers
T u b e p a t h 1 speaker set-up quantity impendance 4 16 ohms cabinets 2 8 ohms cabinets 1 6 ohms cabinet 1 4 ohms cabinet note: the minimum load of the power amplifier is 4 ohms. Connect speakers simplified diagram.
Page 12
Technical data x-treme 5.1 / 10.1 input 25 mv preamp transistor; active controlled poweramp fan cooled (temperature controlled) gain clip led indicates the optimal input level equalizer bass ±10db @ 80hz mid level ±10db (selectable frequency range 250hz to 7khz) hi ±12db @ 9 khz boost +3db / +6db vo...
Page 13: X-Treme
X-treme fuse: fuse: 115 115 v ~ 15 ~ 15 a a 230 v 230 v ~ 8 a x-treme cabinet wca 411 pro (8 ohms) cabinet wca 115 pro (8 ohms) speaker set-up quantity impendance 4 16 ohms cabinets 2 8 ohms cabinets 1 6 ohms cabinet 1 4 ohms cabinet note: the minimum load of the power amplifier is 4 ohms. Connect s...
Page 14
Headquarters: warwick gmbh&co.Music equipment kg • gewerbepark 46 • 08258 markneukirchen/germany • e-mail: info@warwick.De branch china: warwick music equipment (shanghai) ltd., co.• shanghai waigaoqiao free trade zone • shanghai 200131/p.R.China • e-mail: info@warwick.Cn branch uk: warwick music eq...