Washtech Al8 Operator's Manual - page 10

Operating Instructions 

Start up 

Fit drain upstand, wash pump filter,  

scrap trays and shut door. 

Turn wall power switch on and select  

any cycle (1, 2 or 3). 

Power light glows red and machine fills 

automatically. 

Wash Ready light (water symbol) glows 

amber when wash tank is ready. 

Rinse Ready light (tick symbol) glows 

amber when the machine is up to 

required temperature and ready to run. 

Operation 

Select required cycle (1, 2 or 3 for  

2, 4 or 6 minutes cycle accordingly). 

Try cycle 3 initially and switch to faster 

cycles only if necessary. 

Load rack into machine and close door 

to start the machine. 

Cycle light glows green while machine 

operates. 

When Cycle light goes out, cycle is 

complete. 

Open door and remove rack. 

After removing rack from maching, DO NOT shut door as machine 

will start again. 

NOTE: Machine will not operate unless Ready lights are on. 

Shut down every night 

Turn machine and wall power switches off.  

Remove drain upstand to drain wash tank. 

Remove scrap trays and wash pump filter and rinse clean. 

Replace drain upstand, filter and scrap trays.