Wasp WDT2200 User Reference Manual - page 7
.
© 2003 Wasp Technologies, Inc.
- 1 -
WDT2200 Accessories
Figure 0-7: WDT2200 charging / communication cable
Remove Backup Battery Isolator
To prevent power loss during shipping or storage, when you first receive your WDT2200, you will find its backup
battery has been isolated from the contact pin with a transparent plastic film. This may have been removed by the
vendor. If not, remove the insulating film before proceeding.
Install Main Battery
1. Remove the battery door from the WDT2200 by turning the screw on the battery cover counterclockwise.
2. Insert the battery into the main battery chamber by sliding the head (the end with two protruding terminals) into
position first.
3. Reinstall the battery door and tighten the screw.
Cradle
The main battery can be charged by docking it with the WDT2200 charging/communication cradle or by connecting
it directly to a charging /communication cable.
Charging
Before using the WDT2200, the main battery must be installed and fully charged. The WDT2200 is equipped with
a 3.7V 880m.A.H Lithium-Ion battery. It will take 2 to 3 hours to fully charge the main battery.
Cradle LED Icons
This icon indicates communication in progress. When the WDT2200 is transferring data to or
from the host computer. This LED will flash, showing that the data is transferring.
This icon indicates battery charge status. When the cradle is charging the battery; the LED will be
red; when fully charged, the LED will turn green.
T
This LED shows the power status of the cradle itself. When it is lit, the cradle is powered.
Power On
After fully charging the unit, it will be ready for use and may be turned on. Press the power
key on the
keypad to turn on the WDT2200.