Watchdog lt alert monitor receiver user guide this users guide has been developed for the watchdog lt paging alerting receiver..
The usalert watchdog lt pager has been developed specifically for the public safety environment for alerting firemen and other emergency personnel. In addition to public safety systems the watchdog lt pager can be used in any radio system that requires tone alerting and channel monitoring. The all n...
Hold for .75 but less than 1.5 seconds and the pager will enter monitor mode. Press for more than 1.5 seconds and the audio will lock on and remain on continuously until reset. Front control buttons and voice memory control there are three buttons located on the front of the pager for voice memory m...
Audio lock the watchdog lt “audio lock” function allows opening the audio at any time regardless of the three position function switch. Simply depress the reset button for approximately 1.5 seconds. The pager will emit a short beep at 0.75 seconds (continue to hold the reset button) and you will hea...
Auto reset with n time delay - adding the n time delay to revert operation causes the watchdog pager to disregard the state of the carrier during the n time. The n time begins immediately after the alerting cycle and ends on n timeout. At this time the watchdog will enter normal auto reset operation...
Alerting features the watchdog ltis capable of alerting in three different ways. Tone alerting, vibrate alerting and tone / vibrate alerting. The three position function switch can be pre- programmed for the type of alert desired and in which switch position. Tone alerting - if tone alert is selecte...
The two second n time the pager will resume watching the carrier to signal when to stop recording. Watchdog charger the watchdog series charger is both a smart charger and a rapid charger. It will charger both the watchdog pager and a spare set of nimh batteries simultaneously or individually. The r...
