1. DL manuals
  2. Watchman
  3. Monitor
  4. 9-90
  5. Owner's Manual

Watchman 9-90 Owner's Manual

Summary of 9-90

  • Page 1

    Watchman ™ quality manufactured in north carolina catalyst monitor with programmed audio signals models 9-90 and 9-90ac fahrenheit temperature display for catalytic wood-burning stoves & fireplaces owner’s manual condar company • 111 kangaroo drive • columbus, north carolina 28722 • 828.436.2102 •co...

  • Page 2

    1. Consult manufacturer’s manuals when installing a condar watchman™ with any wood- burning stove or fireplace, first consult manufacturer’s manual for catalyst operation information. While visual led read-out is accurate within 50 degrees, target operating temperature or engage-catalyst temperature...

  • Page 3

    Replacing thermocouple cable/probe replaceable thermocouple cable length: 6 feet probe length: 4 inches probe diameter: ¼ inch maximum probe temperature rating: 1950 degrees excessive temperatures and long-term use will wear out the high-temperature probe. If your batteries (9-90) are fresh but the ...

  • Page 4

    Warm-up 250 to 650 degrees during catalyst temperatures in this range, your monitor displays temperatures in 50-degree increments. Some up-and-down readings are normal. At steady 500 degrees or higher, your ceramic catalytic combustor can be engaged. Close the bypass and your catalyst will give you ...

  • Page 5

    Audio signal to engage catalyst audio begins intermittent beep at 500 degrees through 600 degrees. This signal times out after 40 seconds, whether you’ve chosen to engage your catalyst or not. It isn’t necessary to press the audio signal button to remain in audio mode. If you press the button once, ...

  • Page 6

    Notes: condar watchman product warranties thermocouple cable-probe assemblies are warranted by condar company for thirty days from installation, when not subjected to temperatures exceeding 1950 degrees fahrenheit. Monitors are warranted for one year from installation, when properly installed and op...