Water Doctors SYNC-TECH 1.50 Installation Manual - Water Softener
Water Softener
Page 3 of 18
Important Safety Information – Read All
READ Instructions before Using
Before beginning installation, read these instructions completely. Then obtain all the
materials and tools needed for installation.
NOTE:
Failure to install the Water Doctors system correctly voids the warranty.
Perform installation according to state and local plumbing codes.
-
Use only lead-free solder and flux for sweat-solder connections, as required by
state and federal codes.
Handle all components of the Water Doctors system with care. Do not drop, drag or turn
components upside down.
Be sure the floor under the water softening system is clean and level.
The
Water Doctors system uses 120 volt-60Hz electrical power. Always use the power cord
supplied.
-
Plug power cord into an indoor 120 volt, grounded outlet.
-
Properly ground Water Doctors system to conform with all codes and ordinances.
Install
Water Doctors system in a protected area. Be sure electric outlet and transformer do
not come in contact with water. See Where to Install the Softener, in the installation section
of the manual.
-
Do not attempt to treat water over 110°F with the Water Doctors system. Always
connect the Water Doctors system to the main water supply pipe before water
heater.
-
Do not expose Water Doctors system to freezing temperatures. Water freezing in
the system causes equipment damage.
-
Do not install in direct sunlight. Heat from sun may cause damage.
Minimum inlet water pressure is 20 psi. Maximum inlet water pressure is 125 psi. Use
pressure reducing valve if necessary.
Sodium used in the water softening process should be considered as part of your overall
dietary salt intake. Contact physician if you are on a low sodium diet.
Use clean water softening salts only, at least 99.5% pure. Failure to use the correct salt
may create a health hazard or maintenance problems.
-
Use nugget, pellet or coarse solar salts.
-
Do not use rock, block, granulated or ice cream making salts.
Always keep the salt lid in place unless servicing the unit or replenishing salt.
CAUTION
:
Read and follow the information in this manual to
minimize the risk of electric shock or personal injury.
IMPORTANT!
If you are unsure about installing your Water Doctors
water softener, contact Water Doctors helpline or consult a professional
plumber.
IMPORTANT!
This system must be installed in compliance with
applicable state and local codes, law, and regulations.
!
CAUTION:
Do not use with water that is unsafe or of unknown quality.
Test water periodically to verify that the system is performing
satisfactorily.
Discard small parts remaining after the installation.
!