1. DL manuals
  2. Water Factory Systems
  3. Water Dispenser
  4. CoolerMATE CMTRO-75
  5. Owner's Manual

Water Factory Systems CoolerMATE CMTRO-75 Owner's Manual

Summary of CoolerMATE CMTRO-75

  • Page 1

    Instr6064 1209 owner's manual this manual is for the installation, operation, and maintenance of the water factory systems coolermate reverse osmosis systems model cmtro-75 ™ ™ ™ ™ . . System tested and certified by nsf international against nsf/ansi standard 42 and standard 58 for the claims specif...

  • Page 2: Safety Information

    Safety information explanation of signal word consequences warning caution important notes read, understand, and follow all safety information contained in these instructions prior to installation and use of the cmtro-75™ reverse osmosis (ro) drinking water system. Retain these instructions for futu...

  • Page 3

    Cmtro - 75 ™ ro system diagram before beginning the installation, spend a few minutes studying the drawing below. To cooler tank (3/8” blue polyethylene tubing) product water outlet fitting filter icon bayonet filter cartridge 1/4" orange polyethylene tubing ty-rap (used to fasten tubing to cooler) ...

  • Page 4

    I. Installation requirements cmtro-75™ ro system, model cmtro-75 can be used with most coolers that include a storage tank. Check the guidelines below to confirm that the cmtro-75 system you have selected is the correct system for your water conditions and water quality requirements. Feedwater crite...

  • Page 5

    4 1 push in grey collet to release tubing. 2 tubing is secured in. Push tubing straight in as far as it will go. Grey collet tube o-ring 1 pull tubing straight out. 2 to attach tubing to release tubing this product is outfitted with user friendly ‘push-in’ connectors. Proper use of the connectors is...

  • Page 6

    5 7. Reconnect the 3/8” yellow tubing to the back of the filtration assembly. Reconnect the 1/4” orange tubing to the feed water fitting on the filtration assembly. Iii. Flush instructions 1. With the tank valve closed (the tank should still contain the sanitizing solution at this point) disconnect ...

  • Page 7

    6 how to replace the prefilter and postfilter cartridges 1. Close the feed water valve and tank valve, then partially drain the cooler reservoir. Wait five (5) minutes for the assembly to completely depressurize. 2. Twist the filter cartridge 1/4 turn to the left so that the ears on the cartridge ar...

  • Page 8

    Cuno incorporated 400 research parkway meriden, ct 06450 usa toll free 1-800-733-1199 worldwide 1-203-237-5541 fax 1-203-238-8701 www.Waterfactorysystems.Com • www.Cuno.Com © 2009 3m company. All rights reserved. Cuno, cmtro-75 and water factory systems are trademarks of 3m company used under licens...