© 2002 cuno incorporated 98-91121 0902 owner's manual this manual is for the installation, operation, and maintenance of the water factory systems ® faucetmate drinking water appliance ®.
Introduction this manual explains the installation, operation and maintenance of the water factory systems’ faucetmate ® drinking water appliance. Please read each section of this manual carefully. The specific model chosen should be appropriate for the local water conditions and the customer’s need...
Congratulations and thank you for purchasing the water factory systems’ faucetmate ® drinking water system. You are about to enjoy the benefits of high quality drinking water right in your own home. The faucetmate dual-stage filtra- tion systems contain the most effective filtration media for reduci...
F. Make the faucet mounting hole important: it is mandatory that safety glasses by worn during the sink hole drilling operations in order to prevent eye injury. Important: extreme care must be taken when drilling the hole for the faucet. The surface material is hard and brittle and easily chipped or...
5 i. Installing the feed water valve the saddle tapping valve which is supplied is designed to be used on 3/8” - 1/2” od soft copper tubing (plain or chromed) and rigid metal pipe. Do not use with flexible ribbed tubing because it requires special hardware. Optional feed valves should be used for th...
6 feedwater valve faucet figure 1 rubber washer chrome base plate rubber washer plastic bottom washer star washer hex nut figure 2 fm-2 & fm-2 lead plus.
For 3/8" od tubing, use the side of the bracket with the projections. Valve handle stem nut/seal insert plastic sleeve compression nut 1/4" orange feedwater tubing piercing lance for 7/16" to 1/2" od tubing or rigid pipe, use the "v" side of the bracket. 7 figure 3 figure 4 1 push in grey collet to ...
Figure 5 fm-350 dws to faucet outlet fitting with flow control from feedwater source 47-55711g2 47-55707g2 47-55707g2 feedwater inlet 8 note: some state and local plumbing codes may prohibit the use of saddle-type valves and/or drain connections. The use of saddle-type valves are prohibited in: alas...
Cuno incorporated 400 research parkway meriden, ct 06450, u.S.A. Toll free: 1-800-733-1199 worldwide: 203-237-5541 fax: 203-238-8701 www.Waterfactorysystems.Com • www.Cuno.Com.