1/2 hp general purpose water transfer pump model: wstpc50 package contents part description quantity a priming port plug 1 b 3/4 ” npt x 3/4” garden hose fitting 2 c pump 1 d suction strainer 1 questions, problems, missing parts? Before returning to your retailer, call our customer service departmen...
2 specifications power supply required ................................................................................................. 115v, 60 hz water temperature range .................................................................................... Max. 113°f (45°c) individual branch circui...
3 caution: • this transfer utility pump is designed for portable applications. It can drain or remove water from the following: fish tanks, water heaters, pits, sinks, window wells, basements, swimming pool covers, boats, low spots in yards, or other flooded areas. It can also be used for temporary ...
4 preparation warning: always use handle to lift pump. Never use power cord to lift pump. To avoid skin burns, unplug and allow time for the pump to cool after periods of extended use. Estimated assembly time: 5 minutes materials required for assembly (not included): thread tape, 3/4 in. Heavy duty ...
5 1 2. Use the strainer (d) when pumping from a creek, pond, or source where debris may be sucked into the pump. The strainer should prevent debris from entering the inlet line (2). Note: to prevent re-priming during periods of frequent stopping and restarting of the pump (c) , install a foot valve ...
6 operating instructions – transferring water warning: this unit is not waterproof or weatherproof and is not intended to be used in showers, saunas, or other potentially wet locations. The motor is designed to be used in a clean, dry location with access to adequate cooling air. Ambient temperature...
7 care and maintenance danger: risk of electric shock. Always disconnect the electrical supply before attempting to install, service, or perform any maintenance. If the power source is out of sight, lock and tag in the open (off) position to prevent unexpected power application. Failure to do so cou...
8 troubleshooting problem possible cause corrective action pump does not start or run 1. Blown fuse/tripped breaker 2. Low voltage 3. Worn motor brushes 4. Blocked impeller 5. Defective motor 1. Replace fuse or reset breaker 2. If using extension cord, use heavier gauge and shorter cord. 3. See care...
