Water Tec WS1TA Owner's Manual - page 4
GENERAL INSTALLATION & SERVICE CAUTIONS
The control valve, fittings, and/or bypass are designed to accommodate minor plumbing misalignments they are not de-
signed to support the weight of a system or the plumbing.
Do not use Vaseline, oils, other hydrocarbon lubricants, or silicone spray anywhere. Do not use silicone on red or clear lip
seals.
Do not use pipe dope or other sealant on threads. Teflon tape must be used on the threads of the 1" NPT elbow, its ¼"
NPT connec ons, and on the threads for the drain line connec on. Teflon tape is not used on the nut connec ons or caps
because o‐ring seals are used. The nuts and caps are designed to be unscrewed or ghtened by hand or with the special
plas c Service Wrench, CLV‐V3193(models with Clack control valves). If necessary, pliers can be used to unscrew the nut
or cap. Do not use a pipe wrench to ghten nuts or caps. Do not place screwdriver in slots, on caps, and/or tap with a
hammer.
SITE REQUIREMENTS
‐Water Pressure, 20‐125 psi
‐Current draw is 0.25 amperes
‐Water Temperature, 40º‐110º F
‐A 15 . power cord is furnished
‐The tank should be on a firm level surface
‐The plug‐in transformer is for dry loca ons
‐Electrical: Use a 115/120V, 60Hz uninterrupted
only.
outlet.
‐Ba eries are not used.