Water Tech RC32-TM Owner's Manual

Manual is about: REIONATOR Platinum, Classic, Fusion Series

Summary of RC32-TM

  • Page 1

    Owner's manual re ionator ® whole house water conditioner with triton electronic control valve platinum series classic series activate your warranty by registering your product at www.Watertech.Com or call 888-254-8412 wqa gold seal certified to nsf/ansi standards 42 and 44 for meeting or exceeding ...

  • Page 2: Customer Checklist

    Dealer name: dealer phone number: installation date: model number: serial number: customer checklist after installation, installer should make sure of the following: customer has an owner's manual customer knows how to restart system if power goes out customer knows how to put the system in bypass i...

  • Page 3: Maintenance

    Maintenance this manual is applicable to one of the following model numbers: classic series: rc32-tm, rc40-tm, rc48-tm, rc64-tm, rc80-tm platinum series: rp32-tm, rp40-tm, rp48-tm, rp64-tm, rp80-tm fusion series: rf32-tm, rf40-tm, rf48-tm with minimal care, your system is designed to serve you for m...

  • Page 4: Do’S and Do Not’S

    Do’s and do not’s • do always check your state and local regulations regarding plumbing and electrical connections and placement of the system before installation. • do install the reionator ® system into the existing cold water supply line before the water heater and before any cold water outlet th...

  • Page 5: Parts List - Rc/rp

    4 parts list - rc/rp overflow elbow triton control valve product description part number resin tank 9" x 48" 09-03-0948blk resin tank 10" x 47" 09-03-1047blk resin tank 10" x 54" 09-03-1054blk resin tank 12" x 52" 09-03-1252blk resin tank 13" x 54" 09-03-1354blk brine tank assembled 18" x 33" 09-04-...

  • Page 6: Parts List - Rf

    5 parts list - rf product description part number resin tank 10" x 35" 09-03-1035nb resin tank 12" x 35" 09-03-1235nb fusion cabinet top 09-05-010 fusion cabinet base 09-05-011 brine overflow elbow 07-05-004 brine well assembly 09-04-244 triton control valve 13-v1ccdm.

  • Page 7: Plumbing Connection

    Plumbing connection udz zdwhulq udzzdwhuwr rxwvlghidxfhwv frqglwlrqhg zdwhulq krw frog krwzdwhukhdwhu 7ulwrq%\sdvv9doyh typical plumbing installation stop check local codes for minimum run between reionator unit and water heater 6 important: brass or plastic yoke assembly (not shown) is required to ...

  • Page 8: Drain Line Connection

    Drain line connection mdfr mdfr air gap drain line drain elbow nut polytube insert drain elbow locking clip 7 caution: never connect drain line directly into drain, sewer line or trap. Always allow an air gap of at least 25mm (1 inch) or 2 pipe diameters between the drain line and waste water to pre...

  • Page 9: Starting Up The System

    Starting up the system flushing, conditioning and sanitizing did you connect the drain line securely to the valve? Did you connect the brine line securely to the valve? Step 1. Make sure the system is in the “bypass” position before turning the main water back on. See page 12. Make sure the drain li...

  • Page 10: Starting Up The System

    Starting up the system step 3: continued: once the valve has completed the “brine fill” cycle it will automatically return to service. In step 5 you will set the valve to “regen today” so that it will regen tonight at the specified time. If there is any residual chlorine, it should be removed tonigh...

  • Page 11

    Displays & programming instructions general operation: when the reionator ® is in operation, one of two displays will be shown. The user can alternate between the two displays as desired by pressing the ‘next’ button. System operation is not affected by pressing the ‘next’ button. One of the display...

  • Page 12: Set Time of Day / Power Loss

    Set time of day / power loss the user can also set the time of day. Time of day should only need to be set after extended power outages or when daylight saving time begins or ends. If a power outage lasting longer than two hours occurs, the time of day will flash on and off which indicates the time ...

  • Page 13: Bypass Valve Operation

    Bypass valve operation the bypass valve is typically used to isolate the control valve from the plumbing system’s water pressure in order to perform control valve repairs or maintenance. The 1 " full flow bypass valve incorporates four positions including a diagnostic position that allows service pe...

  • Page 14: Bypass Valve Illustrations

    Bypass valve illustrations figure 1 normal operation position figure 2 bypass operation position figure 3 diagnostic mode position figure 4 shut off mode position 13.

  • Page 15: Specifications

    Specifications watertech recommends the use of potassium chloride (kcl) as a regenerant salt. * the efficiency is only valid at the stated salt dosage and maximum service flow. † specifications apply to all rc/rp/rf models. 1 softening efficiency values based on nacl as the regenerant salt. 2 soften...

  • Page 16: Specifications

    15 specifications the reionator ® is a dir (demand initiated regeneration) softener which complies with specific performance specifications intended to minimize the use of regenerant brine in its operation. This water softener conforms to nsf/ansi standard 42 for reduction of aesthetic chlorine and ...

  • Page 17: Notes

    16 notes.

  • Page 18: Notes

    17 notes.

  • Page 19: Notes

    18 notes.

  • Page 20: Reionator

    Watertech industries residential reionator ® limited lifetime warranty applicable to reionator ® models: classic series rc32-tm, rc40-tm, rc48-tm, rc64-tm, rc80-tm platinum series rp32-tm, rp40-tm, rp48-tm, rp64-tm, rp80-tm fusion series rf32-tm, rf40-tm, rf48-tm watertech industries (wti) hereby wa...