Water Well V65A User Manual - 6. Technical Data
4
5
Image 1
3. Fill the filter bottle with 2lt of water and allow to filter into the water
dispenser. (NOTE: The first couple of filtrations through a filter bottle
may be slow)
4. Drain and discard the water from the water dispenser using the taps
and repeat point 3 twice more. (until water is clear in the bottom
compartment of the filter bottle.
5. Follow instructions 5 & 6 of the water dispenser installation
instructions.
5. Installation of Standard Water Bottle
1. After rinsing,fill your standard water bottle with water and secure the
bottle cap onto the bottle neck.
2. Invert the bottle and pierce the bottle neck onto the spike in the
middle of the bottle support, ensure the standard bottle is sitting level
on the water dispenser. See Images 1 - 3 above
3. Follow instructions 5 & 6 of the water dispenser installation
instructions.
Image 2
Image 3
2. Insert the Filter Bottle, with the Bottle Valve attached into the open
area (Reservoir Tank) on
top of the water dispenser,
ensure that the Filter Bottle
sits level on the top of the
water dispenser.
See Images 4 - 5
Image 4
Image 5
Model No.:
V65A (BD90)
Rated voltage Frequency:
220 - 240V / 50Hz
Rated Cooling Power:
120W
Cold water capacity:
1.0l/h
Optimum Cold Water Temperature: ≤ 10˚C
Optimum Environmental Ambient 10˚C - 32 ˚C
Temperature
6. Technical Data
7. Circuit Diagram
Red
SW2
Tem
p
contro
lI
SW1
Cooling
assembly
Yellow
Heater
Temp control II
L
E
N
Green
NOTE: Technical data, circuit diagram & rating plate may be changed
without prior notice