Waterax BB-4-18/23 Quick Manual

Summary of BB-4-18/23

  • Page 1

    01/2015 1 bb-4-18/23 quick guide this quick guide shows the basic operation of the waterax bb-4-18/23 4-stage high pressure pump.  the waterax bb-4 pump model pairs a waterax 4- stage pump end with a briggs & stratton vanguard 18 hp or 23 hp gasoline engine. For engine instructions, oil and fuel re...

  • Page 2: Parts Identification

    Bb-4-18/23 quick guide 2 01/2015 parts identification a. Priming cap b. Pump intake (suction) c. Pump drain port (not shown) d. Pump discharge e. Quick release pump clamp f. Low-tone muffler g. Fuel pump (not shown) h. Fuel valve* (not shown) i. Starter key switch** (not shown) j. Rewind starter (no...

  • Page 3

    Bb-4-18/23 quick guide 01/2015 3 4. Prime the pump. Check that all drains, discharge valves, or any auxiliary valves are closed before priming the pump. Open the priming ball valve (located between the pump and the primer). Manual priming: open the priming cap and fill pump with water manually. Firm...

  • Page 4

    Bb-4-18/23 quick guide 4 01/2015 to shut down and store the bb-4-18/23 unit: 1. Shut down the pump. A. Gradually reduce the engine speed. B. Whenever the unit has been run at full throttle for most of the operation, allow the valves to remain slightly open and run the engine at idle for approximatel...