Waterco ElectroheatSubZero Supplementary User And Care Manual Manual

Manual is about: HEAT PUMP

Summary of ElectroheatSubZero

  • Page 1

    Www.Waterco.Com warning ! Heat pump electroheat subzero supplementary user and care guide manual this equipment must be installed and serviced by a qualified technician. Improper installation can create electrical hazards which could result in property damage, serious injury or death. Improper insta...

  • Page 2

    Table of a note to you ----------------------------------------------------- 01 subzero ------------------------------------------------------------ 01 general safety instructions -------------------------- 02 installation instructions ------------------------------- 03 location of subzero ---------...

  • Page 3: A Note To You

    A note to you thank you for buying our waterco heat pump pool heater a heat pump pool heater is a highly efficient, cost effective method of pool heating. Intelligent operation and care will result in many years of enjoyment and pleasure. Please note that this handbook is a complement to the general...

  • Page 4

    To ensure your safety and the adequate functioning of your heat pump, all electrical work should be performed by a fully qualified and licensed electrician in accordance with local electrical codes. An adequate circuit breaker and copper wiring must be used. Refer to the electrical installation diag...

  • Page 5: Installation Instructions

    I pg 03 heat pump swimming pool heaters installation instructions location of subzero the location of the pool heater is very important in keeping installation costs to a minimum, while providing for maximum efficiency of operation as well as allowing adequate service and maintenance access. Mount t...

  • Page 6: To Start-Up The Unit

    Operation of your pool heater operation of multi-function electronic control panel the display of the control panel is factory set to show pool water temperature in degrees fahrenheit. See “to select temperature in °c or °f” section in the general user handbook. To start-up the unit when the unit is...

  • Page 7: Defrost Cycle Subzero

    I pg 05 heat pump swimming pool heaters to select pool or spa mode the electronic board has the capability of memorizing two different programmed temperature settings as follows: for a pool maximum 35˚c for a spa maximum 40˚c to have access to either one of these programs, press the set key until yo...

  • Page 8: Winterizing

    Winterizing if the unit is stored in a place where the temperature drops below the freezing point of 0°c, it is mandatory that the water accumulated in the unit be drained completely before freezing weather prevails. The water piping must be disconnected to drain the heat exchanger in preparation fo...

  • Page 9: Service Analyser Codes

    I pg 07 heat pump swimming pool heaters service analyser codes most problems will be detected by the service analyser and a code will be displayed on the digital display of your heater. Display meaning of code off the desired programmed temperature point is lower than 15°c. Lp & lp3 shortage of refr...

  • Page 10

    Waterco limited abn 62 002 070 733 (zzm1332) 03/2010 offices - australia nsw - sydney (head office) tel : +61 2 9898 8686 vic/ tas - melbourne tel : +61 3 9764 1211 wa - perth tel : +61 8 9273 1900 qld - brisbane tel : +61 7 3299 9900 sa/ nt - adelaide tel : +61 8 8244 6000 act distributor tel : +61...