Waterco MultiCyclone 70XL User Manual - Filter Maintenance
Waterco Multicyclone 70Xl
I pg 03
3. Connect to Waste Line.
Glue the plumbing from the Sediment Purge Valve to your waste line.
4. Turn on pump.
Be sure to check that there are no leaks from the connectors. If required, tighten by hand.
FILTER MAINTENANCE
Filter maintenance determined by the following conditions:
1. The flow rate through the MultiCyclone 70XL is insufficient to meet the demand.
2. The sediment chamber is half filled with sediment.
The accumulation of sediment can be visibly monitored through the MultiCyclone 70XL’s clear sight
glass. The MultiCyclone 70XL is cleaned by simply opening the purge valve
FLUSHING OUT THE SEDIMENT CHAMBER
Whilst the water pump is running simply open the sediment purge valve until the sediment has been
flushed out. This is visible through the clear sight glass.
Once the sediment has been flushed out, close the sediment purge valve.
WARRANTY
MultiCyclone 70XL is covered by a 2 warranty.
For more information please refer to the Waterco “Warranty Terms & Conditions” booklet. With our
on going commitment to quality products and service Waterco Limited reserves the right to alter the
product in any manner and at any time without prior warning.
This information is to the best of our knowledge, accurate at the time of printing. Any recommendations
or suggestions are made without warranty and without prejudice, since the use of our product is
beyond our control.