Waterco W33850 Installation And Operation Manual

Summary of W33850

  • Page 1

    Waterco limited abn 62 002 070 733 (w33850) 07/2010 offices - australia nsw - sydney (head office) tel : +61 2 9898 8686 vic/ tas - melbourne tel : +61 3 9764 1211 wa - perth tel : +61 8 9273 1900 qld - brisbane tel : +61 7 3299 9900 sa/ nt - adelaide tel : +61 8 8244 6000 act distributor tel : +61 ...

  • Page 2

    Waterco fulflo pressure pump important safety instructions when installing and using this electrical equipment, basic safety precautions should always be followed, including the following: read and follow all instructions danger do not block the pump suction, as this will cause severe or fatal injur...

  • Page 3

    Table of waterco fulflo pressure pump introduction ------------------------------------------------------ 01 application suitability ----------------------------------------- 01 assembly & installation --------------------------------------- 01 operation ---------------------------------------------...

  • Page 4

    Waterco fulflo pressure pump assembling the waterco fulflo pressure pump unit i pg 03 3. If you have purchased a pressure pack; a. Wrap 3-4 turns of teflon tape onto the male threaded end of the pressure pack and screw on the tee fitting. B. Wrap 3-4 turns of teflon tape onto the male threaded end o...

  • Page 5

    Waterco fulflo pressure pump methods of installation the waterco fulflo pressure pump pressure system can be installed in as follow; flooded suction – a good quality check valve should be installed in the suction line. Note : laws governing electrical installations must be observed and electricians ...

  • Page 6

    Waterco fulflo pressure pump troubleshooting guide waterco strongly recommends you have a qualified service technician service your pump. However, many problems may be solved by consulting the table below. Symptom possible cause action motor won’t start or run no power supply check for blown/ trippe...