WaterGroup Aquaflo H-PR-10-34 Installation And Operating Instructions
Cartridge Selection (For Filter Housing Model # H-PR-10-34,H-10-34, WCT34SS & WVIH34SS)
Cartridge Filter Size 2.5” X 10”
Select the Cartridge Filter
for your water needs
PCP-5-10
(Part# 26175)
RF-10
(Part# 26254)
PC-20-10
(Part# 26008)
SW-10-10
(Part# 26246)
WSW30 or
SW-30-10
(Part# 26010)
WSW05 or
SW-5-10
(Part# 26011)
WC-10 or
CGAC-10
(Part# 26006)
WT10 or
ICDP-5-10
(Part # 26009)
SPB-5-10
(Part# 26222)
SPB-1-10
(Part#
26213)
Filter Type
Pleated
Cellulose
Cartridge -
Polyester
Radial Flow
Granular
Activated
Carbon
Pleated
Cellulose
Cartridge
String Wound
Polypropylene
String Wound
Polypropylene
String Wound
Polypropylene
Granular Acti-
vated Carbon
Dual Purpose
- Carbon
Impregenated
Cellulose
Spun Poly
Bonded
Spun Poly
Bonded
Scale and Rust Particles
X
X
X
X
X
X
X
X
Coarse Sand
X
X
X
X
X
X
X
X
Sand/Dirt/Silt
X
X
X
X
X
X
X
X
Fine Dirt/Silt/Sand
X
X
X
X
X
X
Extra Fine Dirt/Silt/Sand
X
X
X
X
X
Bad Taste & Odor
X
X
X
Aethetic Chlorine: Taste & Odor
X
X
X
Filter Life (in months)*
6
6
6
6
6
6
6
6
6
6
Micron Rating (Nominal) +
5
20
10
30
5
–
5
5
5
Service Flow Rate gpm (lpm)**
5 (18.9)
1 (3.7)
5 (18.9)
10 (37)
10 (37)
10 (37)
1.5 (5.6)
1.5 (5.6)
Cartridge Selection (For Filter Housing Model # H-PR-20-34 & H-20-34)
Select the Cartridge Filter
for your water needs
PCP-5-20
(Part# 26177)
RF-20
(Part# 26253)
PC-20-20
(Part# 26182)
SPB-5-20
(Part# 26221)
Filter Type
Pleated Cellulose
Cartridge - Polyester
Radial Flow Granular
Activated Carbon
Pleated Cellulose
Cartridge
Spun Poly
Bonded
Scale and Rust Particles
X
X
X
Coarse Sand
X
X
X
Sand/Dirt/Silt
X
X
X
Fine Dirt/Silt/Sand
X
X
Extra Fine Dirt/Silt/Sand
X
X
Bad Taste & Odor
X
Aethetic Chlorine: Taste & Odor
X
Filter Life (in months)*
6
6
6
6
Micron Rating (Nominal) +
5
20
5
Service Flow Rate gpm (lpm)**
7 (26)
2 (7.4)
7 (26)
2 (7.4)
*NOTE: Filter cartridge life varies depending on usage and water conditions
**NOTE: Flow rates measured at 60psi (4.1 bar)
The smaller the micron rating, the smaller the size particle the cartridge will filter. For comparison purposes, the human hair has a diameter of ap-
proximately 70 microns. Particles smaller than 40 microns are not visible with the human eye
*NOTE: Filter cartridge life varies depending on usage and water conditions
**NOTE: Flow rates measured at 60psi (4.1 bar)
The smaller the micron rating, the smaller the size particle the cartridge will filter. For comparison purposes, the human hair has a diameter of ap-
proximately 70 microns. Particles smaller than 40 microns are not visible with the human eye
L
L
L
L
Troubleshooting
Leaks between cap and bottom of housing:
1. Turn off water supply and depress pressure-relief button.
2. Clean and lubricate O-ring with silicone grease. Also, clean the groove where the
o-ring seats. Replace o-ring back in groove above threads. Screw bottom of housing
back on cap securely by hand. Do not overtighten.
3. Turn on water supply. If leaks persist, or if there are other leaks on the system, turn
off water supply. Call your dealer.
Leaks on inlet/outlet connections:
1. Turn off water supply. For brass fittings, tighten nut 1/2-turn with wrench.
2. Turn on water supply. If leaks persist, or if there are other leaks on system, turn off
water supply. Call your dealer.
Replacement Parts
1
2
Housing # Housing Model #
O-Ring,
Sump
Wrench
Bracket with
Hardware
Sump
+ O-ring
26262
H-PR-10BV-34
92512
92509
92514
-
26258
H-PR-10BV-1
92512
92509
92514
-
26261
H-PR-20BV-34
92512
92509
92514
-
26259
H-PR-20BV-1
92512
92509
92514
-
26263
H-PR-20BV-15
92512
92509
92514
-
26264
H-PR-10-34
92513
92508
92515
-
26066
WCT34SS
92060
26007
26023
26049
26065
WVIH34SS
92060
26007
92516
26049
26265
H-PR-20-34
92513
92508
92515
-
1
1
2
2
3
3
3
Replacement Part – WVI34SS
Item #
Item Description
1 & 2
26057
Clear Sump C/W O-Ring
2
26055
O-Ring, Sump
3
26056
Wrench
4
26059
O-ring Cap,Side
3
2
1
4
WARNING: Do not use with water that is micro-
biologically unsafe or of unknown quality without
adequate disinfection before or after the system.
CAUTION: The filters must be protected from freez-
ing. Failure to do so may result in the cracking of
the filter and water leakage.
Limited Warranty
This warranty is valid for twelve months from the date of purchase as verified by a bill of sale.
If this product is found to be defective in the judgment of the manufacturer, a replacement or
equivalent replacement product will be provided at no charge. The manufacturer assumes no
responsibility for consequential damage, labor or expense incurred as a result of a defect or
for failure to meet the terms of this warranty because of circumstances beyond its control.
Retain this document for your records along with your proof of purchase.
Date Installed:_________________
SOLD BY:
WaterGroup Companies Inc.
Regina, SK; Cambridge, ON; Fridlley, MN
www.watergroup.com
54997.0312
Aquaflo Filter Housing
InStALLAtIOn AnD OperAtIng InStructIOnS
54997.0312
Tools Required
• 2 adjustable wrenches • file
• pipe threader
• 2 pipe wrenches
• pencil • pipe cutter or hacksaw
Materials Required (not included)
Depends on type, size, and location of pipe on which filter will be
installed. Measure the pipe to determine what size nipples, union,
and valve you will need. Depending on the pipe size, you will also
need to purchase the appropriate size fittings. Consult your local
hardware store to learn more about your particular installation needs.
NOTE: Galvanized fittings must be used with galvanized pipe.
Optional Materials
• jumper wire
Model# H-PR-10BV-34, H-PR-10BV-1,
H-PR-20BV-34, H-PR-20BV-1, H-PR-20BV-15,
H-PR-10-34, WCT34SS, WVIH34SS, H-PR-20-34
NOTE: This filter housing does NOT include a filter cartridge.
Choose the appropriate filter cartridge for your needs and install in hous-
ing according to the Cartridge Replacement instructions before proceed-
ing with installation. See cartridge selection chart.
Specification
Pressure Range
30–100 psi (2.1–6.9 bar)
Temperature Range:
40–100°F (4.4–37.7°C)
Housing Material
Polypropylene (blue) & AS (clear)
Housing O-Ring Material
EPDM
Parts Included
• filter housing
• housing wrench
• bracket with mounting hardware
Housing # Housing Model # Filter Size
Inlet/Outlet
Size (Inches)
Dimension
(inches) A
Dimension
(inches) B
26262
H-PR-10BV-34
4.5” X 10”
3/4”
7.25”
14”
26258
H-PR-10BV-1
4.5”X10”
1”
7.25”
14”
26261
H-PR-20BV-34
4.5”X20”
3/4”
7.25”
24”
26259
H-PR-20BV-1
4.5”X20”
1”
7.25”
24”
26263
H-PR-20BV-15
4.5”X20”
1.5”
7.25”
24”
26264
H-PR-10-34
2.5”X10”
3/4”
5.25”
12.25”
26066
WCT34SS
2.5” x 10”
3/4”
5.25”
12.25”
26065
WVIH34SS
2.5” x 10”
3/4”
5”
13.5”
26265
H-PR-20-34
2.5” x 20”
3/4”
5.25”
22.5”
Filter Housing Specifications (Table 1)
B
A
A
B