Installation and owner’s manual for fusion 360™ residential reverse osmosis drinking water systems this manual is to be left with the owner of the equipment for reference purposes and technical guidance. It is strongly recommended that qualified dealer service personnel be contacted in the event of ...
2 congratulations! You have purchased the finest residential drinking water system available for your home. It will provide you years of reliable service if properly installed, operated and maintained. Please read this entire manual before attempting installation and operation. Section 1. Frequently...
3 ! Fusion 360™ drinking water systems are designed only to improve aesthetic properties and are not designed to act as a primary barrier to waterborne microbiological or toxic chemical contamination. Where these conditions may exist consult a water professional to ensure sufficient raw water pre-tr...
4 section 2. Unpacking and installation your system includes: 9 the ro filtration cabinet assembly. Depending on the model, your four-stage ro unit may have a booster pump installed inside the cabinet. The booster pump model will have a cord and wall plug adapter attached. 9 one self-piercing cold w...
5 2. Keep in mind that you may install a tube tee on the line to the faucet to connect icemakers or other faucets to the system. If you locate your system farther than 20 feet from the faucet, you will need to add a pressure booster pump to your system. See your dealer for parts and details. Step 2....
6 3. You may now turn the water supply to your home on. Check for leaks around the saddle. Tighten, reseat or reinstall if necessary. Step 4. Install the sink faucet tools required for this step: an electric drill, a 5/8” carbide bit, a small adjustable wrench, a center punch, a pencil, a rat-tail f...
7 step 5. Install the drain saddle assembly 1. Select the location to install the drain saddle assembly. This is usually on the sink drainpipe and needs to always be located above the “s” trap. 2. Position the drain saddle assembly in the selected location and mark the spot through the outlet with a...
8 figure 5a. Figure 5b. Cabinet tube connections 1. See figure 5b above. This rear view of the cabinet shows the three water connections that must be made to the cabinet. When cutting the tube lengths, be sure to allow enough tube for the cabinet to be placed in its final position and then to be pul...
9 step 7. Starting up the fusion 360 filtration system 1. See figure 5a above. Using the phillips-head screwdriver, remove the screw as shown. This will allow you to slide off the cabinet cowling from the rear. The top detachable cover may also be removed by sliding it out towards the rear. See figu...
10 5. Open water supply saddle valve and let ro system fill with water. For roc101e models, the booster pump should start pumping immediately. Check for leaks on all internal and external joints and repair any leaks by reseating the tube in the fitting, if necessary. 6. Let the system operate for ab...
11 5. Grasp with the top cartridge (aip12 - see figure 12) and gently pull out of its mounting clips. Repeat with the aic12 and aic10 cartridges. Disconnect each from its tubing connections (note blue c-clips must be removed first) and replace with the replacement cartridge. Make sure each tube is r...
12 section 4: troubleshooting guide trouble shooting guide possible cause solution low water or no water water supply valve closed or ro tank valve closed. Open valves low home water pressure must exceed 40 psi. If lower, install booster pump – see dealer crimped poly tube repair or replace tube fil...
13 fus ion² 360 ™ ro drinking water system common parts list calculating your ro system’s daily output the pressure and temperature chart following will help you determine what daily output you can expect from your fusion 360 ro system. Your ro system is rated to produce 100 us gallons per day, or a...
14.
15 page left intentionally blank.
16 page left intentionally blank waterite technologies, inc. 3-75 meridian drive winnipeg, manitoba canada r2r 2v9 (204) 786-1604 (204) 783-1599 fax www.Waterite.Com.
