Installation and owner’s manual for vectapure 360 ™ drinking water systems this manual is to be left with the owner of the equipment for reference purposes and technical guidance. It is strongly recommended that qualified dealer service personnel be contacted in the event of an unknown interruption ...
2 congratulations! You have purchased the finest residential drinking water system available for your home. It will provide you years of reliable service if properly installed, operated and maintained. Please read this entire manual before attempting installation and operation. Section 1. Frequently...
3 yes. Ro and uf membranes will eliminate most bacteria, viruses and parasites such as cryptosporidium from the water. However, where these conditions exist, pre-filters and other system components located before the membrane will become contaminated from exposure to them. Cross contamination of the...
4 section 2. Unpacking and installation your system includes: the v360 filtration unit assembly with colour-coded cartridge(s). Depending on the model, you will have a single, dual or triple uf filtration unit or a four-stage ro unit. The cartridge(s) have been pre-inserted into the filter body. A...
5 keep in mind that you may install a tube tee on the line to the faucet to connect icemakers or other faucets to the system. If you locate your system farther than 20 feet from the faucet, you will need to add a pressure booster pump to your system. See your dealer for parts and details. Step 2. Ge...
6 step 4. Install the sink faucet too ls required for this step: an electric drill, a 5/8” carbide bit, a small adjustable wrench, a center punch, a pencil, a rat-tail file. Your dealer will be able to supply a variety of designer faucets and finishes to suit your particular installation, if you wis...
7 step 5. Install the drain saddle assembly (v360 ro system only) 1. Select the location to install the drain saddle assembly. This is usually on the sink drainpipe and needs to always be located above the “s” trap. 2. Position the drain saddle assembly in the selected location and mark the spot thr...
8 step 7. Mounting the filtration unit 1. While holding the v360 system in its intended mounting position, mark the holes for the wall screws with the pencil . Using a 1/8” bit, drill the pilot holes for the screws. 2. (for v360 single filter systems) position the bracket and screw in the mounting s...
9 3. (for v360 ro systems only) connect the drain tube from the bottom of the ro membrane to the drain saddle, by first cutting to the desired length and then inserting the tube into the push-on drain fitting. Make sure tube cuts are clean and square and the tube is fully inserted into the fitting. ...
10 soft water free from iron is idea for long membrane life. Hardness, iron, chlorine and infrequently changed filter cartridges are the membrane’s greatest enemies. Uf membrane life is significantly reduced if local water authorities inject a polyphosphate additive to municipal water to inhibit wat...
11 section 4: troubleshooting guide trouble shooting guide possible cause solution low water or no water water supply valve closed or ro tank valve closed. Open valves low home water pressure must exceed 40 psi. If lower, install booster pump – see dealer crimped poly tube repair or replace tube fil...
12 vectapure 360™ drinking water system common parts list calculating your ro system’s daily output the pressure and temperature chart below will help you determine what daily output you can expect from your v360 ro system. Your ro system is rated to produce 75 us gallons per day, or approximately 2...
13.
14 page left intentionally blank.
15 page left intentionally blank.
16 waterite technologies, inc. 3-75 meridian drive winnipeg, manitoba canada r2r 2v9 (204) 786-1604 (204) 783-1599 fax www.Waterite.Com.
