Installation & operating instructions under cabinet plumbed-in beverage system with programmable clock/timer and lighted display model: ap-ucbs-kit unit shown with optional tall carafe, medium size carafe is included) 961 n. Main street, mansfield, oh 44903 419.529.3949 • 800.522.3949 • fax 419-529-...
Page 2 thank you for purchasing the alwaysfreshh2o beverage system. Over 75 years of experience in designing and manufacturing commercial brewing equipment goes into every brewer. Matching commercial quality components with consumer friendly features have created the best brewer available for the re...
Page 3 important information & safeguards read all instructions and safeguards carefully and completely before installing or operating this equipment. Save all instructions for future reference. To reduce the risk of fire or electric shock, do not remove covers. There are no end user serviceable par...
Page 4 appliance information appliance specifications: model numbers: ap-ucbs descriptions: ap-ucbs-kit with programmable clock/timer and lighted display dimensions: 13” w x 3-9/16” h x 7-3/16” d volts: 120 watts: 1600 amps: 13.6 hertz: 60 phase: 1 power supply cord: 4 ft., 3 wire w/ground plug: nem...
Control locations and descriptions fig. 1 1. “+” button press to adjust the clock (hr) and or adjust the time (hr) for “brew start time”. 14. Toggle switch (on-off-fill) turns on the power to the coffee appliance and fills the tank prior to use. 2. “-” button press to adjust the time (min.) and or a...
Installation instructions warning: read these installation instructions completely before connecting this brewer to a power supply or water supply. The water tank must be filled with water for this brewer to function properly. Warning: incorrect installation or operating procedures will void the war...
Plumbing connection: (see fig. 3 below for a typical water line connection.) note: this brewer is designed to operate with water pressure of 30 to 80 psi. If the water pressure exceeds 80 psi, it is recommended that a water pressure regulator (not included) to be installed and reduce the water press...
Electrical connections: make sure the power switch toggle (fig.1 item #14) is in the off (middle) position before connecting the power supply cord to prevent damage to the machine. Refer to fig. 4. A. Connect the power supply cord into the proper power supply outlet as indicated on the electrical na...
Operating instructions caution: read these instructions completely before operating this brewer. Caution: make sure the installation instructions have been followed before attempting to operate this brewer. Incorrect installation or operating procedures will void the warranty and may cause damage to...
Adjustments and programming your brewer : (see fig. 7) (all machines starting from serial no. 3432583 and higher) setting the clock: fig. 7 1. Press and hold the “program” button for approximately 3 seconds to enter program mode. The colon (:) on the display will begin to flash and a beep is emitted...
Page 11 setting automatic brew time: (note: the clock must be set in order to have “brew start time” functioning.) note: once set, “brew start time” is stored in the brewer’s internal memory and will be the default “brew start time” unless changed or the unit is reset. 1. Press and hold the “program...
Page 12 re-setting automatic brew time: (for the next day) note: the clock must be set in order to have “brew start time” functioning. 1. Press and hold the “program” button for approximately 3 seconds to enter program mode. The colon (:) on the display will begin to flash and a beep is emitted by t...
Maintenance & cleaning fig. 8 caution: only those persons trained and qualified in equipment repair should attempt to open and clean the inside of this appliance. Caution: turn the power switch off, unplug the power supply cord and allow the brewing appliance to cool before cleaning. Note: do not us...
Page 14 troubleshooting service should be performed by qualified service personnel only. Warning: turn off the "power-fill” toggle switch. Unplug the power supply cord and allow the coffee appliance to cool before servicing unless electrical testing is required. Warning: make sure installation instr...
Page 15 symptom possible causes remedies 10. Poor tasting coffee. Water deposits are plugging the spray head or siphon tube. The brewing temperature has not been adjusted correctly. The amount of coffee being used may not be correct. More than one paper filter was used when brewing. The brewer appli...
Page 16 limited warranty manufacturer warrants this product to be free of defects in material and workmanship for a period of three (3) years from the original date of purchase. Within this warranty period, it will repair or replace, at its option, any part providing it's defective in material or wo...
Accessories & cleaning supplies: these accessories are available from waterline for use on your alwaysfreshh2o built-in beverage center. For more information, please call waterline at 1-800-522-3949 or e-mail us at waterline@alwaysfreshh2o.Com paper coffee filters – waterline part no. 6000415 (repla...
Accessories & cleaning supplies: brew cone for system – waterline part no. Ap-cone (replacement) stainless steel construction for use with digital ucbs only (model ap-ucbs-kit) quick reference guide for ucbs. – waterline part no. Ap-guide (replacement) contains programming and settings information s...
Page 19 notes:.
1-800-522-3949 www.Alwaysfreshh2o.Com.
