WaterLogic Water Filtration Systems Service Manual

Summary of Water Filtration Systems

  • Page 1

    The hybrid service guide watch the video online: www.Waterlogicfirewall.Com/ products-hybrid-water-purifier/ f-fweg1-m-a-nt-**-*** warning: boil the water should the purification unit fail.

  • Page 2: 1. Pure Kit Contents

    1.1 remove the items from the box. Hold the uv lamp by the plastic edges, and avoid touching the glass parts as this may affect the performance of the lamp 1.2 please check the contents of the box and make sure that all items are present 1.3 if any of the items are missing please contact customer se...

  • Page 3

    3 2.1 remove the water reservoir from the main body of the appliance. This can be cleaned with a light solution of dishwashing liquid. Never use abrasive chemicals or materials to clean the reservoir as this could scratch and deface the product 2.2 remove the two screws that hold the top cover in pl...

  • Page 4

    2.4 disconnect the uv lamp connector by holding it and pressing in the clip on the connector and pulling it up 2.5 to remove the uv lamp firmly pull it up and out. Do not pull the lamp out at an angle as it may break or damage the internal parts of the appliance note: the uv lamp must be disposed of...

  • Page 5

    5 2.7 re-connect the uv lamp connector making sure the connectors are lined up correctly as they will only fit together when correctly aligned 2.8 to remove the filter, do the following: 1. Rotate the red rotating lever so that it is parallel with the side panel 2. Insert your finger into the round ...

  • Page 6

    2.10 re-fit the top cover, making sure the front is attached first. If the top cover is not fitted correctly the unit will not switch on hint: fit the top cover making sure the front is pushed in place first and then push the back end with the screws down to give a snug fit 2.11 re-fit the two screw...

  • Page 7

    7 2.14 re-fit the reservoir to the appliance making sure it is firmly fitted 2.15 place a glass or large container under the dispense area and touch the dispense button to operate the unit, and touch again to stop the appliance. Allow water to run through the unit until the reservoir has been emptie...

  • Page 8: X3-4

    2.17 repeat steps 2.13-2.16 three to four times (3x - 4x). This will flush the carbon from the new filter 2.18 once step 2.17 has been completed you can drink purified, healthy and safe water from your appliance during the first week of use and after every filter change you may notice water dripping...

  • Page 9: 3. Cleaning

    9 3. Cleaning it is recommended that you maintain your appliance by cleaning it on a regular basis. The appliance can be cleaned using a damp lint free cloth. Never use any alcohol or alcohol based chemicals or abrasive materials on any part of the product. 4. Storage do not store the pure kit in da...

  • Page 10

    5. Safety 6. Disposal • do not touch or look directly into the faucet • do not handle or lift the appliance by holding the reservoir • only authorised trained technicians may carry out repairs on this appliance • the filter and uv lamp must be replaced every 12 months. • the user may only replace th...