1. DL manuals
  2. WaterLogic
  3. Water Dispenser
  4. WL100
  5. Technical Manual

WaterLogic WL100 Technical Manual

Summary of WL100

  • Page 1

    Waterlogic 100 technical manual - issue b, september 2011 wl100 technical manual.

  • Page 2

    2 3 waterlogic 100 technical manual - issue b, september 2011 index machine overview 4 mains parts layout - hot and cold 8 pre delivery inspection procedures (pdi) 9 installation procedures 10 operating instructions 14 maintenance and servicing 16 sanitising or descaling 17 fault finding 18 technica...

  • Page 3: Machine Overview

    4 5 waterlogic 100 technical manual - issue b, september 2011 5 machine overview waterlogic 100 tthe wl100 is available in the following options: a) cold and ambient b) hot and cold when reading this manual, note the differences between the options and focus on the particular sections that concern t...

  • Page 4

    6 7 waterlogic 100 technical manual - issue b, september 2011 filters the filtration system on the wl100 is designed to reduce dirt and sediment particles from the water. Furthermore, the activated carbon process will remove a whole range of contaminants e.G. Chlorine and pesticides. There are many ...

  • Page 5: Main Parts Layout

    8 9 waterlogic 100 technical manual - issue b, september 2011 main parts layout hot and cold fil ter fil ter in (water) solenoid valve solenoid valve hot water out cold water out air vent filter dryer cold sensor cold tank hot tank compressor condenser pre delivery inspection procedures (pdi) cautio...

  • Page 6: Installation Procedures

    10 11 waterlogic 100 technical manual - issue b, september 2011 installation procedures important notice: this procedure should only be carried out by a technician trained by waterlogic international or by an approved distributing agent. Note: this appliance is intended for indoor use only. Cleaning...

  • Page 7

    12 13 waterlogic 100 technical manual - issue b, september 2011 installation kit for installation, you will need: 1-20 metres of 6mm 5/16 inch water pipe, prv (pressure reducing valve) set at 3 bar or 42 psi, non-return valve, self-cutting saddle valve or isolating valves, moulded plug fitted, co2ga...

  • Page 8: Operating Instructions

    14 15 waterlogic 100 technical manual - issue b, september 2011 the option buttons are very simple to identify. The following instructions apply for both the hot and cold, and cold and ambient machines. Hot water caution • always place cup / mug in the centre of the drip tray. • always use a ceramic...

  • Page 9: Maintenance And Servicing

    16 17 waterlogic 100 technical manual - issue b, september 2011 12. Wipe the outside surfaces (non abrasive cleaner), clean the drip tray, check there is a 5cm air gap around the wl100. 13. Taste the water, ensure there are no carbon fines in the water, check the wl100 functions to the customer’s sa...

  • Page 10

    18 19 waterlogic 100 technical manual - issue b, september 2011 7. Low flow of water for all circuits of the machine: ensure that the filter is not blocked. The filter may require changing, or there is low water supply pressure. 8. Low flow of hot water: indicates that the hot tank needs to be de-sc...

  • Page 11: Technical Specifications

    20 21 waterlogic 100 technical manual - issue b, september 2011 description f-100-fs-hc f-100-m-hc width depth height 345w*367d*1030h 345w*367d*457h water connection 1/4" hose cold water temp. 5-8°c hot water temp. 85-90°c weight 28kg 23kg power supply ac 220-240v / 50hz control & unit 610w 610w hea...

  • Page 12: Main Pcb Schematic Diagram

    22 23 waterlogic 100 technical manual - issue b, september 2011 main pcb schematic diagram hot and cold end of life non eu countries at the end of this product’s life, please ensure that it is disposed of in an environmentally friendly manner which is in line with your country requirements/guideline...

  • Page 13: Wetted Parts Illustration

    24 25 waterlogic 100 technical manual - issue b, september 2011 wetted parts illustration wetted parts list 4 8 1 2 3 56 7 99 29 28 20 21 20 19 17 22 16 15 14 11 12 13 10 25 24 26 23 27 18 no description remark 1 bulkhead fitting 1/4"x 1/4"(st) 2 1/4" blue tube(st) 3 equal elbow connector 1/4" 4 10”...

  • Page 14: Main Parts Illustration

    26 27 waterlogic 100 technical manual - issue b, september 2011 main parts illustration exploded view diagram main parts list 39 39 37 35 36 38 25 26 27 28 24 23 34 33 32 31 30 29 1 2 4 6 7 5 8 9 12 20 22 21 16 18 19 17 15 14 13 40 11 10 3 no description 1 top cover 2 thermostat 3 back panel 4 switc...

  • Page 15: Main Parts List

    28 29 waterlogic 100 technical manual - issue b, september 2011 main parts list no description 26 front panel for drip tray insert 27 plastic pcb cover 28 pcb for wl100 29 front hatch panel 30 silicon button key mat 31 button cover 32 label 33 drip tray grill 34 drip tray body 35 power transformer u...

  • Page 16

    30 eng0092-21/11/13 wli trading ltd. Suite 4, 2nd floor beacon court, sandyford, dublin 18, ireland www.Waterlogic.Com waterlogic usa, 4141 n. 156th street, omaha, ne 68116 speak to a water expert rest of the world exportsales@waterlogic.Com + 353 1 293 1960 usa, canada and mexico info@waterlogicusa...