Summary of WL3000
Page 1
Wl3000 technical manual - may 2014 wl3000 technical manual.
Page 2
2 3 wl3000 technical manual - may 2014 index technical manual welcome to your new waterlogic machine. This technical manual is to help you get great tasting water cup after cup by making the most of the product’s features. Declaration waterlogic international ltd 1. The installation, maintenance and...
Page 3: Machine Overview
4 5 wl3000 technical manual - may 2014 5 machine overview wl 3000 cold tank the cold tank is manufactured from 304 stainless steel which is noncorrosive, inert and reflects ultraviolet light. The temperature of the cold tank is controlled by a microprocessor and can be set between 3 degrees and 12 d...
Page 4
6 water valves dispensing of water to the customer is achieved by means of a 24v dc electrical solenoid valve. The valves are energized every time the customer pushes the dispense button for a drink. Dc voltage is used to give a positive and quieter action of the solenoid valve. Plastic panels the m...
Page 5: Main Parts Layout
8 9 wl3000 technical manual - may 2014 main parts layout cold, hot and sparkling models main parts layout cold & hot models fil ter fil ter in (water) solenoid valve 1 solenoid valve 2 solenoid valve 5 hot water out hot water out w ater in cold w ater out sparkling water out air vent solenoid valve ...
Page 6: Main Parts Layout
10 11 wl3000 technical manual - may 2014 main parts layout cold & ambient models fil ter fil ter in (water) cold water out ambient water out air vent filter dryer cold sensor cold tank drain valve compressor condenser fan motor faucet out (water) uv lamp solenoid valve 1 solenoid valve 2 main parts ...
Page 7: Main Parts Layout
12 13 wl3000 technical manual - may 2014 main parts layout cold only models fil ter fil ter in (water) solenoid valve cold water out air vent filter dryer cold sensor cold tank drain valve compressor condenser fan motor faucet out (water) uv lamp pre delivery inspection procedures (pdi) 1. Unpack an...
Page 8: Installation Procedures
14 15 wl3000 technical manual - may 2014 installation procedures important notice: this procedure should only be carried out by an engineer or staff trained by waterlogic international or an approved distributing agent. Note: this appliance is intended for indoor use only and must not be installed i...
Page 9: Instructions
16 17 wl3000 technical manual - may 2014 instructions on changing the co 2 bottle removing the empty bottle turn off the empty bottle and disconnect from gas regulator. Connecting new bottle • before connecting new bottle, remove dust cap. • face the gas bottle away from yourself and open for 3-5 se...
Page 10: Operating Instructions
18 19 wl3000 technical manual - may 2014 operating the machine is very simple. Firstly, place a cup in the dispense area. Then simply select the drink of your choice and press the dispense button until your cup is filled to the required level. Operating instructions hot water caution • always place ...
Page 11
20 21 wl3000 technical manual - may 2014 note: default mode is cold water note: default mode is cold water note: default mode is cold water cold and ambient cold and sparkling cold only cold 8°c cold 8°c cold 8°c cold water push cold water button. Push dispense button, cold water will be dispensed. ...
Page 12: Programming Instructions
22 23 wl3000 technical manual - may 2014 programming instructions programming of the wl 3000 will depend upon the type of the machine: the buttons have the following functions: button 1 scroll the menu down button 2 scroll the menu up button 3 enter an option on the menu button 4 escape to main menu...
Page 13: Menu Options
24 25 wl3000 technical manual - may 2014 menu options menu options brief description cold temp set 3°- 12°c the temperature of the still water can set between 3°to 12°c. Recommended temperature 5°c hot temp set 70°- 95°c the temperature of the hot water can be set between 70°to 95°c. Recommended tem...
Page 14: Maintenance And Servicing
26 27 wl3000 technical manual - may 2014 maintenance and servicing 6 month service procedure the following instructions are for a full option machine (hot, cold and sparkling). • every six months the filters and uv lamp should be changed. • please remember that the machine should not be exposed to d...
Page 15
28 29 wl3000 technical manual - may 2014 sanitizing the machine 1. You will need to have an empty in-line filter housing to follow this procedure. Also sanitiser, disposable rubber gloves, and bacterial wipes or spray. 2. Mix a solution of sanitiser in the empty in-line filter housing. 3. Turn off t...
Page 16: Technical Specifications
30 31 wl3000 technical manual - may 2014 troubleshooting the following faults will be shown on the lcd display should that particular fault occur. 1. Change filter: please contact your authorised sevice agent. 2. Drip tray full: empty and clean the drip tray. 3. Hot fault: indicates a sensor fault. ...
Page 17: Environmental Information
32 33 wl3000 technical manual - may 2014 environmental information refrigeration gas information note: this information is provided as guidance only. Energy consumption will be effected by incoming water temperature, room - temperature and usage patterns. Figures in brackets apply when sleep mode is...
Page 18: How Carbonated Water
34 35 wl3000 technical manual - may 2014 how carbonated water is created safety valve cold water from tank level probe pump carbonated water pcb co2 gas supply co2 water to faucet red black non-return valve non-return valve rohs all waterlogic machines comply with ec directive (2002/95/ec) on the re...
Page 19: Electrical Wiring Diagram
36 37 wl3000 technical manual - may 2014 electrical wiring diagram cold, hot and sparkling main pcb schematic diagram cold, hot and sparkling a 230v from red switch b 230v to uv ballast c output to uv lamp d 230v to heater e 230v from green switch f 230v to compressor g level probe h cold thermostat...
Page 20: Electrical Wiring Diagram
38 39 wl3000 technical manual - may 2014 electrical wiring diagram cold and hot main pcb schematic diagram cold and hot danger high voltages present on this pcb care must be taken when live testing mark description mark description 20s1 hot solenoid valve ps1 control power switch 20s2 cold solenoid ...
Page 21: Electrical Wiring Diagram
40 41 wl3000 technical manual - may 2014 electrical wiring diagram cold and ambient main pcb schematic diagram cold and ambient danger high voltages present on this pcb care must be taken when live testing mark description mark description 20s2 cold solenoid valve ps1 control power switch 20s3 ambie...
Page 22: Electrical Wiring Diagram
42 43 wl3000 technical manual - may 2014 electrical wiring diagram cold and sparkling main pcb schematic diagram cold and sparkling danger high voltages present on this pcb care must be taken when live testing mark description mark description 20s2 cold solenoid valve ps1 control power switch 20s3 s...
Page 23: Electrical Wiring Diagram
44 45 wl3000 technical manual - may 2014 electrical wiring diagram cold only main pcb schematic diagram cold only danger high voltages present on this pcb care must be taken when live testing mark description mark description 20s2 cold solenoid valve ps2 comp & heater power switch bt ballast q 5 tra...
Page 24: Wetted Parts List
46 47 wl3000 technical manual - may 2014 wetted parts list cold, hot and sparkling models no. Part description 1 1/4” bulkhead fitting 2 1/4” pe tube 3 1/4” stem elbow 4 filter head *5 carbon filter (customer specific) 6 1/4” equal elbow 7 solenoid valve double 8 5/16" & 1/4” reducing elbow 9 5/16" ...
Page 25: Main Parts Illustration
48 49 wl3000 technical manual - may 2014 main parts illustration hot & cold models main parts list hot & cold models 3 9 22 13 20 18 18 19 9 21 2 23 2 4 1 *5 2 2 2 2 16 6 6 6 8 7 2 10 14 15 15 11 12 18 18 23 22 22 22 22 22 22 22 22 no. Part no. Part description 1 pu-4028 1/4” bulkhead fitting 2 pu-4...
Page 26: Wetted Parts List
50 51 wl3000 technical manual - may 2014 wetted parts list cold and ambient models no. Part description 1 1/4” bulkhead fitting 2 1/4” pe tube 3 1/4” stem elbow 4 filter head *5 carbon filter (customer specific) 6 1/4” equal elbow 7 solenoid valve double 8 5/16” tube 9 1/4” drain valve 10 quartz sle...
Page 27: Wetted Parts List
52 53 wl3000 technical manual - may 2014 wetted parts list cold and sparkling models wetted parts list cold and sparkling models 17 16 15 14 13 13 11 10 10 12 17 21 22 20 19 18 26 26 17 8 7 12 6 6 6 6 6 6 6 6 *5 *5 4 9 3 3 3 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 1 1 29 24 23 no. Part description 1 1/4” bulk...
Page 28: Wetted Parts List
54 55 wl3000 technical manual - may 2014 wetted parts list cold only models wetted parts list cold only models 17 18 16 15 14 13 12 11 10 8 7 6 6 *5 4 9 3 2 2 2 2 1 *customer specific no. Part description 1 1/4” bulkhead fitting 2 1/4” pe tube 3 1/4” stem elbow 4 filter head *5 carbon filter 6 1/4” ...
Page 29: Main Part List
56 57 wl3000 technical manual - may 2014 main part list models wlmhc3000/wlmcw3000 no. Part description 1 drip tray with wl logo drip tray with no logo 2 front panel for drip tray insert 3 filter housing bracket 4 valve head 5* domestic filter 6 front metal panel 7 side panel 8 front door panel 9 h/...
Page 30
58 59 wl3000 technical manual - may 2014 no. Part description 38 cord socket 39 fuse (10a) 40 fuse holder 41 power switch (red) 42 heater & comp switch (green) 43 hot tank drain valve 5/16” 44 cold tank drain valve 1/4” 45 bulk head fitting 46 side panel 47 cds fixing rubber 48 thermal cut-out 105°c...
Page 31
60 eng0490-21/05/14 wli trading ltd. Suite 4, 2nd floor beacon court, sandyford, dublin 18, ireland www.Waterlogic.Com waterlogic usa, 11710 stonegate circle omaha, ne 68164 speak to a water expert rest of the world exportsales@waterlogic.Com + 353 1 293 1960 usa, canada and mexico info@waterlogicus...