1. DL manuals
  2. Watermaid
  3. Swimming Pool Filter
  4. Rapid Kleen 26"
  5. Installation And Operating Instructions Manual

Watermaid Rapid Kleen 26" Installation And Operating Instructions Manual

Summary of Rapid Kleen 26"

  • Page 1

    ® water treatment since 1971 south australia 91 carlisle street ethelton sa 5015 phone: (08) 8242 4880 new south wales 24 tepko road terrey hills nsw 2084 phone: (02) 9450 0244 other quality watermaid® products include: salt water chlorinators water treatment units pool & spa pumps copyright © water...

  • Page 3

    Watermaid® sand filters 10 copyright © watermaid pty ltd record purchase date record starting pressure after initial startup backwashing: psi/kpa. Table of contents your watermaid® sand filter .................................................. Installation & operation instructions .....................

  • Page 4

    Watermaid® sand filters 9 copyright © watermaid pty ltd terms and conditions 1. This guarantee applies to all states and territories of australia only and is subject to the provisions of the trade practices act and goods and consumer protection legislation of the various states. 2. The guarantee per...

  • Page 5

    Your watermaid® sand filter congratulations on your purchase of this quality, australian made watermaid® product. Watermaid® sand filters will give you peace of mind in knowing that one of your major investments is being treated by a quality filtration system which can be relied upon to perform effi...

  • Page 6

    Installation and operation instructions location * the watermaid® filter should be placed as close to the pool as possible on a concrete slab as large as dimension "c" given on page 6. * allow sufficient space around the filter for routine maintenance which will also allow for adequate ventilation a...

  • Page 7

    Watermaid® sand filters 3 copyright © watermaid pty ltd 11. Place the valve flange clamps in place and checking the alignment of the ports, tighten firmly (by hand). 12. Apply teflon tape to the thread on the pressure gauge and screw into the multiport valve body. 13. Complete all plumbing connectio...

  • Page 8

    5 watermaid® sand filters copyright © watermaid pty ltd normal filter cycle 1. Position the handle on the valve to 'filter' and start the pump. 2. With a clean filter, record the pressure gauge reading in the space provided on the specifications sticker or mark the needle position on the pressure ga...