1 section i n d o o r c y c l e c o m p u t e r i n s t r u c t i o n s.
2 www.Watersfitness.Com installing the computer 1) computer bracket the computer bracket mounts to the underside of the handlebar. The easiest method of installation is to remove the handlebar from the cycle and lay it on a flat surface with the insert post pointing up. You should see two indentatio...
3 installation 4) speed sensor bracket the speed sensor bracket is installed on cycles that come with a speed sensor braze-on. The braze-on is located on the backside of the left fork. Unscrew the braze-on bolt, and attach the speed sensor bracket with the washer and bolt. Install the bracket pointi...
4 www.Watersfitness.Com lcd display liquid crystal display distance display kilometers (km) or miles (mile) speed display kilometers per hour(kph) or miles per hour(mph) heart rate display your heart rate/pulse is displayed in beats per minute (bpm). Note: if the letter”p” is displayed then the comp...
5 instructions time display hours, minutes and seconds calories display measured in kilocalories (k/cal). Also known as large calories and food calories. Rpm / cadence display revolutions per minute (rpm) note: calories and rpm share the same display. Press the down q key to alternate the display wh...
6 www.Watersfitness.Com battery installation remove the battery cover at the rear of the computer and install two size “aa” 1.5v batteries. Replace the battery cover and insure it is tightly closed. Battery life battery life is approximately six months of home use, depending on the frequency of use ...
7 trouble shooting solutions 1) speed sensor direction: check to ensure that the speed sensor is pointed towards the wheel magnet. 2) computer reset: press and hold the enter key for three seconds. 3) computer reboot: disconnect the power for approximately 15 seconds by removing the batteries. Wait ...
Waters fitness, llc 740 pierce st., waterloo wi 53594 888.850.9973 f: 262.923.1000 www.Watersfitness.Com.
