Installation guide and operating manual proswitch -xtreme proswitch -xtreme extreme temperature ethernet switch corporate headquarters manufacturing/customer service 5001 american blvd., w. Suite 605 945 37 th avenue, nw bloomington, mn 55437 rochester, mn 55901 phone: 800.441.5319 phone: 800.328.22...
Waters network systems proswitch-xtreme operating manual page 1 table of contents 1.0 introduction......................................................................................................................2 1.1 product description .............................................................
Waters network systems proswitch-xtreme operating manual page 2 1.0 introduction 1.1 product description the proswitch-xtreme extreme temperature ethernet switches are designed to operate in abnormal temperature applications, and are suitable for use in harsh environments with inhospitable high/low ...
Waters network systems proswitch-xtreme operating manual page 3 thermal design enables the proswitch-xtreme to be used in uncontrolled temperature applications. The proswitch-xtreme’s advanced thermal packaging with rugged 18-gauge high steel enclosures used as a heat sink is designed specifically f...
Waters network systems proswitch-xtreme operating manual page 4 1 2 3 4 5 6 10 magnum p62f gar re tt magnum p62f gar re tt magnum p62f ga rre tt 10 10 10 10 100 server 3.0 applications the proswitch-xtreme is designed specifically for harsh temperature environments and brings future-proof fiber and ...
Waters network systems proswitch-xtreme operating manual page 5 4.0 specifications 4.1 technical specifications ports performance fiber, and when an auto-negotiating port is operating at 100mbps: data rate: 100mbps when an rj45 auto-negotiating port is operating at 10mbps: data rate: 10mbps network ...
Waters network systems proswitch-xtreme operating manual page 6 led indicators pwr: steady on when power applied speed (when link is on): on = 100mbps; off = 10mbps link/act: steady on for link with no traffic, blinking indicates port is transmitting/receiving. F/h (rj45 ports only): on = full-duple...
Waters network systems proswitch-xtreme operating manual page 7 5.3.1 connecting twisted pairs the following procedure describes how to connect a 10base-t or 100base-tx twisted pair segment to the rj45 port. The procedure is the same for both unshielded and shielded twisted pair cables. 1. Using sta...
Waters network systems proswitch-xtreme operating manual page 8 the following data has been collected from component manufacturer’s (hp’s and siemens’) web sites and catalogs to provide guidance to network designers and installers. Fiber port module speed, std. Mode std. Km fdx (hdx) wave- length nm...
Waters network systems proswitch-xtreme operating manual page 9 6.0 operation 6.1 dual-speed functionality and switching the proswitch-xtreme ethernet switch provide six 10/100 rj45 switched ports, and two 100mbps fiber ports. The architecture supports a dual-speed switching environment, with two bu...
Waters network systems proswitch-xtreme operating manual page 10 7.1 before calling for assistance 1. If difficulty is encountered when installing or operating the unit, refer back to the installation section of the chapter of this manual. Also check to make sure that the various components of the n...
Waters network systems proswitch-xtreme operating manual page 11 connectors and this installation guide.) caution: do not pack the unit in styrofoam "popcorn" type packing material. This material may cause electro- static shock damage to the unit. Clearly mark the return material authorization (rma)...
