Owner's manual soft max whole house water softener with triton electronic control valve activate your warranty by registering your product at www.Watertech.Com or call 888-254-8412.
Dealer contact and product information • do always check your state and local regulations regarding plumbing and electrical connections and placement of the system before installation. • do install the system into the existing cold water supply line before the water heater and before any cold water ...
Maintenance with minimal care, your system is designed to serve you for many years. While constant attention to your system is not necessary, the following suggestions will insure your system’s performance and your convenience and satisfaction. Maintenance • salt in the brine tank is used as a resin...
Plumbing connection udz zdwhulq udzzdwhuwr rxwvlghidxfhwv frqglwlrqhg zdwhulq krw frog krwzdwhukhdwhu 7ulwrq%\sdvv9doyh typical plumbing installation stop check local codes for minimum run between unit and water heater important: brass or plastic yoke assembly (not shown) is required to connect pipi...
Drain line connection mdfr mdfr air gap drain line drain elbow nut polytube insert drain elbow locking clip caution: never connect drain line directly into drain, sewer line or trap. Always allow an air gap of at least 25mm (1 inch) or 2 pipe diameters between the drain line and waste water to preve...
Starting up the system flushing, conditioning and sanitizing did you connect the drain line securely to the valve? Did you connect the brine line securely to the valve? Step 1. Make sure the system is in the “bypass” position before turning the main water back on. See page 12. Make sure the drain li...
Starting up the system step 3 continued : once the valve has completed the “brine fill” cycle it will automatically return to service. In step 5 you will set the valve to “regen today” so that it will regen tonight at the specified time. If there is any residual chlorine, it should be removed tonigh...
Displays & programming instructions general operation: when the system is in operation, one of two displays will be shown. The user can alternate between the two displays as desired by pressing the ‘next’ button. System operation is not affected by pressing the ‘next’ button. One of the displays is ...
Set time of day / power loss the user can also set the time of day. Time of day should only need to be set after extended power outages or when daylight saving time begins or ends. If a power outage lasting longer than two hours occurs, the time of day will flash on and off which indicates the time ...
Bypass valve operation the bypass valve is typically used to isolate the control valve from the plumbing system’s water pressure in order to perform control valve repairs or maintenance. The 1 " full flow bypass valve incorporates four positions including a diagnostic position that allows service pe...
Bypass valve illustrations figure 1 normal operation position figure 2 bypass operation position figure 3 diagnostic mode position figure 4 shut off mode position 10
Watertech industries residential softmax softener 5/10 year warranty applicable to: soft max series watertech industries (wti) hereby warrants said equipment, only to the original purchaser at the original installation location. This warranty period begins at the time of initial installation and use...
