Watter Saver HPWH500AAOC Installation, Operation And Maintanance Manual - page 4
Made In Rome, NY, USA
Watter$aver Heat Pump Water Heater
4
!
!
!
!
!
!
!
!
TAMPERING AND MODIFICATION
DANGER
Tampering with the thermostat, heater elements, elec-
trical connections, or temperature and pressure re-
lief valve is dangerous and may result in serious in-
jury or death. Tampering voids all warranties. Only
properly trained, qualified service personnel should
service these components. Do not attempt to modify
or change this water heater in any way.
INSULATION BLANKET
Some governing bodies may require the use of external
insulation blankets when water heaters are installed in
newly constructed homes and additions. If an insulation
blanket is applied to the Watter$aver Heat Pump Water
Heater, CAUTION must be exercised so as to not restrict
its proper function and operation. Please note the following:
• Do not cover the temperature and pressure relief
valve or any labels or instruction materials applied to
the water heater. These labels must remain visible
for reference by the user. Do not remove these labels
as they are a permanent part of the water heater as
required by the certification agencies and/or the
Federal Government.
• Do not cover any doors on the water heater or
access panels leading to element compartments.
• Do not cover any opening on the shroud that will
obstruct air flow inlet or outlet to the water heater.
EARTHQUAKE NOTICE
WARNING
This water heater must be braced, anchored, or
strapped to avoid falling or moving during an earth-
quake. Contact local utilities for code requirements
in your area or call the toll free number on the front of
this manual for instructions.
SITE LOCATION
Select a location near the center of the water piping
system. It must be installed indoors and in a vertical
position on a level surface.
WARNING
Do not install outdoors!! This water heater is
certified for indoor installation only. Failure to follow
these instructions could result in fire, property
damage, personal injury or death.
The Watter$aver should be located in an area not subject
to physical damage by moving vehicles or area flooding.
(Figure 1.)
Water heaters located in unconditioned spaces (attics, base-
ments, etc.) may require the water piping and drain piping
to be insulated to protect against freezing. The drain and
controls must be easily accessible for operation and ser-
vice.
The Watter$aver Heat Pump Water Heater should be lo-
cated in an area where leakage of the tank or connections
will not result in damage to the area adjacent to the water
heater or to lower floors of the structure.
IMPORTANT: Local codes and requirements in your
area may require the installation of your water heater
be accomplished in a way that the bottom of the unit
is elevated at least 6 inches (15 cm) from the floor.
WARNING
Areas where flammable liquids (gasoline, solvents,
liquid propane, butane, etc.) or other substances
which emit flammable vapors are stored are not suit-
able for water heater installation. Natural air move-
ments can carry flammable vapors some distance
from where they are stored or used. The water heater
thermostat contacts can arc and ignite these vapors
causing property damage, serious burns or death.
Never store or use flammable substances in the same
room or area containing an electric water heater.
Gasoline or other flammable substances must never
be used in the same room or area containing a water
heater or other spark producing devices.
It is recommended that a suitable drain pan be installed
under the water heater to protect the property from damage
which may occur from normal condensate formation on
the tank or leaks in the tank and pipe connections. The
pan must limit the water level to a maximum depth of 2½
inches (6.3 cm) and be 2 inches (5.1 cm) wider than the
heater and piped to an adequate drain. Locate the water
Figure 1
Residential Garage Installation
Vehicle Stop
Drain
Drain Pan