Installation, operation and maintenance manual warning please read carefully before proceeding with installation. Your failure to follow a attached instructions or operating parameters may lead to the product's failure and possible damage to property. ************************************************...
Thank you for your purchase of a watts reverse osmosis system. With proper installation and mainte- nance, this system will provide you with high quality water for years to come. All of watts water enhance- ment products are rigorously tested by independent laboratories for safety and reliability. I...
Operational parameters do not use with water that is microbiologically unsafe or of unknown quality, without adequate disinfection before or after the system. Operating temperatures: maximum 100°f (37.8°c) minimum 40°f ( 4.4°c) operating pressure: maximum 100 psi (7.43 g/cm2) minimum 40 psi (2.80 kg...
Caution: porcelain sink surface material is extremely hard and may crack or chip. Use extreme caution when drilling. Watts accepts no responsibility for damage resulting from the installation of the faucet. Step 1 determine desired location to drill a hole for the faucet on your sink. Step 2 using a...
Hand tighten brass nuts then apply 1/4 turn with a wrench. For 3/8” plumbing for 1/2” plumbing ro tubes will be connected on page 6. Step 6 turn off the hot and cold water supply to the faucet by turning the angle stop valves off. Step 7 remove water supply line at faucet to the angle stop valves. S...
6 step 11 connect blue tube from in-line filter over to the faucet shank. Place the brass nut onto the tube, followed by the plastic sleeve (tapered end pointing to the end of tube) and then place the brass insert into the end of the tube. Step 12 insert the blue tube into the end of the faucet shan...
Apply teflon tape in a clockwise direction around the male pipe threads on the tank. Thread the ball valve (supplied in the parts bag) onto the stainless steel connector on the tank. Note: do not over tighten plastics connections. Step 16 installation of storage tank step 15 7 step 18 postion the ta...
Start up instructions step 1 turn on the incoming hot and cold water angle stop valves. Turn on the water line needle valves by turning counter clock- wise. Check the system for leaks and tighten fittings as neces- sary. Note: check daily over the next week to ensure no leaks are present. Step 2 plu...
Step 7 inspect o-rings for wear and replace them if needed (order part no. Wp113029 from watts.) lubricate o-rings with a water soluble lubricant such as ky jelly®, (petroleum based lubricants such as vaseline® must not be used.) be sure to properly seat the o-ring in the housing before threading th...
10 membrane maintenance membrane filters have a life expectancy of 2 to 5 years, depending on the incoming water conditions and the amount of use of the ro system. If at any time you notice a reduction in water production or a change in the taste of the ro water, it could be time to replace the memb...
Trouble shooting problem cause solution low/slow production excessive air pressure in tank relieve pressure at schrader valve on tank (set to 7 psi with the tank empty) pump not operating wiring connection broken (plug 110 ac wall plug back in at wall and/or reconnect the 24 vac wire harness connect...
Adjust faucet if the faucet has developed a drip it can be corrected by following the steps outlined below. Step 1 remove faucet spout first. Position both thumbs on the back edge of the lever and push forward. Step 2 lever will slide forward and completely off of the faucet base. Step 3 small brass...
Service record date of purchase date of install installed by serial no. / / / / name: # date of (6 mos.) (6 mos.) (1 yr.) (2-5 yrs.) other maintenance 1st stage 2nd stage final filter tfm memb. Sediment carbon block carbon notes: 13.
What your warranty covers: limited 3 year warrranty on the reverse osmosis module, tank and faucet if defective. 1 year warranty on the electrical components, pump, pressure switch, solenoid valve, and transformer if defective. No warranty onreplaceable filters and membranes. Return unit after obtai...
15.
Watts premier has other fine water filtration products and accessories to enhance your water and to compliment your existing ro system. Listed on the next several pages are only a few of the items we offer. Visit our website at www.Wattspremier.Com or call our customer service representatives at 1-8...
Wave faucets by watts premier allow for a variety of choices to match your kitchen decor. Available colors include: part no. 116022 chrome $30.95 part no. 116010 white $27.95 part no. 116026 black $27.95 part no. 116021 almond $27.95 part no. 116002 black on chrome $25.95 part no. 116006 white on ch...
Filtered showers...”you can feel the difference” chlorine in your shower…. It kills germs, bacteria and other microorganisms. It also readily passes through cell walls, and attaches to fatty acids in the cell, disrupting life-sustaining functions. The human body is composed of billio ns of similar c...
19.
