Wattson Classic Electronics FY-2 Fuzz Owner's Manual - page 2
2
Thank You!
We'd like to thank you for purchasing the FY-2 Fuzz, from Wattson Classic
Electronics.
We've designed the FY-2 Fuzz to provide the exact same tone and visual
appeal as the classic FY-2 effect from Shin-ei. We've also made some
improvements over that classic design, including a rugged 16 gauge steel
chassis, an external DC power jack, an LED which lights when the effect is
engaged, and a convenient battery drawer that allows you to swap batteries
without opening the case.
Please read through this brief manual to ensure that you get the most from
your FY-2 Fuzz pedal.
Installing a battery
Your FY-2 Fuzz can be operated from either an external 9VDC power supply,
or a conventional 9V battery. For battery operation we recommend you use
only alkaline batteries.
To remove the battery drawer - place your fingernail or a small coin in the slot
at the bottom of the drawer, and lift upward until the drawer "clicks".
If there is already a battery in the drawer then the drawer should pop out
slightly on it's own. Otherwise, pull lightly on the drawer with your fingernail
until it begins to slide out of the case. Grasp the drawer and remove it
completely from the case.
The battery is held in the drawer by pressure from a spring. You
can remove the battery from the drawer by lifting outward at the
end with the connector snaps.
Insert a fresh battery in the drawer. Be sure to observe the
proper polarity or the battery will not fit in the drawer correctly.
Insert the drawer into the case, battery side facing up and connector snaps
toward the case. Push the drawer into the case until it "clicks".