Wattson Solar Plus User Manual - page 7
Troubleshooting.
No lights on your Wattson when you switch it on?
1 / Make sure the display unit is connected to power or its batteries are
fully charged. Full battery charge takes around 24 hours but Wattson can
still display your energy use whilst it charges. Note that Wattson does not
charge via the USB connection.
2 / Reset Wattson manually (as described on page 15)
If Wattson hasn’t heard from the transmitter for a little while it will show
OUT OF RANGE on its display.
1 / Take Wattson closer to the transmitter.
2 / Check that the transmitter LED is flashing. If not check the power
supply or transmitter batteries and replace if necessary.
3 / If the display unit has a flashing dot on the left of the display and
the OUT OF RANGE message then you may need to re-pair the display and
transmitter (see page 15).
Can’t attach the sensor clip to your electricity wire?
If there is not enough space to simply attach the clip to one of the wires
please consult a certified electrician. They may be able to fit the clip
within your fusebox or distribution unit. DO NOT under any circumstance
attempt this yourself.
If Wattson displays 0W
1 / Check that you have at least one electrical appliance switched on.
2 / Check that the transmitter LED is flashing (see OUT OF RANGE).
3 / Check that the sensors are firmly plugged into the transmitter.
4 / Check that the sensor clips are connected to a single-cored electrical
wire. This is the most common cause of zero readings.
If you still are still having trouble, please submit a support ticket at the
HelpDesk, diykyoto.helpserve.com.
12
DIYKYOTO.COM
/F
AQ
ALSO SEE F
AQS
ON OUR WEBSITE
Safety guide.
13
To avoid power surge disruption,
disconnect the cable between the
sensor clip and transmitter during any
electrical storm.
Do not use Wattson in or near water
or in high moisture areas such
as the bathroom.
Do not use the sensor clip and
transmitter outside. Outdoor usage of
the Wattson will invalidate
your warranty.
Keep Wattson away from
heat sources such as radiators,
stoves, heaters and any other
heat-generating products.
Do not leave old/used batteries in the
transmitter unit for any length of time
and remove batteries when using DC
power supply as they may leak and
cause corrosion.
If Wattson is misused or you do not follow these
instructions Energeno Ltd can not be held liable
for any losses or injury that may result.