Wavedecor Evaluation Kit 5 User Manual - User Manual
Copyright © 2008 by Wavecor Ltd., GuangZhou, China. All rights reserved.
Wavecor ® is a registered trademark of Wavecor Ltd.
USER MANUAL
Page
Evaluation Kit 5
Package content
If you have purchased your Wavecor Evaluation Kit 5 as a complete kit, the package should contain the following
parts:
piece main cabinet (sides/top/bottom/back panels assembled) including white cabinet stuffing and
port tube
piece mid/woofer model WF8WA02 with gasket for cabinet sealing
piece tweeter model TW00WA0 with gasket for cabinet sealing
piece separate cabinet baffle with gasket, including the following screws
4 pcs M4 for mounting the tweeter
4 pcs M4 for mounting the woofer
piece crossover/terminal cup assembly with gasket for cabinet sealing and 4 wires for connecting the
drive units, including 4 pieces wood screws
piece front grille with grille cloth
Putting the parts together
Assembly instructions.
CAUTION! Always work with the cabinet on a soft, clean surface to avoid scratches.
Be careful not to over-tighten any of the screws during assembling.
STEP
Mount the crossover/terminal cup assembly in the rear cut-out hole. Attach it with the 4 wood screws and make
sure the four wires are pulled through the white stuffing inside the cabinet all the way through to where the drive
units will be located.
STEP 2
Solder the wires to the woofer terminals (the wide terminal is the positive) and then attach the woofer using the
four M4 screws.
STEP 4
Solder the wires to the tweeter terminals (the wide terminal is the positive) and then attach the tweeter using the
four remaining M4 screws.
DONE!