¯ 2004 wave frontier co t55 installation manual for toroidal 55 multi-beam satellite antenna.
¯ 2004 wave frontier co t55 parts list.
¯ 2004 wave frontier co t55 assembly diagram.
¯ 2004 wave frontier co t55 the illustration shows how signal travels through toroidal. Signals are reflected twice; 1 st on the main reflector and 2 nd on the sub reflector. This is how toroidal can capture multiple signals within 40 degrees in arc. [in other words, you can capture satellites from ...
¯ 2004 wave frontier co t55 ൡ check your assembly (sub reflector) follow the assembly diagram to assemble your toroidal. Check the orientation of your sub reflector and guide as illustrated on the figure. (o) is the correct assembly of sub reflector. ൡ check your assembly (back mount unit) check the...
¯ 2004 wave frontier co t55 please refer to the setup information provided to you. If you have not received the information, please request your zip code specific information at the “setup info” section on www.Wavefrontier.Us . Assemble holder parts by hand at this stage. Adapter will be required if...
¯ 2004 wave frontier co t55 ൡ elevation tip: you will be making adjustment on elevation, skew and azimuth angles when optimizing your setup throughout the process. Do not use excessive force when assembling moving parts. Very important: make sure that your pole mount is in absolute vertical position...
¯ 2004 wave frontier co t55 ൡ tip if possible, align toroidal on the ground level with your receiver and monitor right next to toroidal. (or use a sat finder equipment). It is much faster, easier and safer. ൡ azimuth setting 1. Connect your receiver to the center lnbf (closest one to the center). Do...
¯ 2004 wave frontier co t55 the alignment process of toroidal is to adjust two lines in parallel. Assume that “a” line is formed by your lnbfs and “b” line is formed by your target satellites. The alignment process of toroidal is to make these two lines parallel. In reality, the line b is not a stra...
¯ 2004 wave frontier co t55 the final step would be changing a skew angle to align a & c. After the skew angle adjustment: x lnbf a: 95% x lnbf b: 95% x lnbf c: 95% the adjustment of skew angle is same as adjusting the elevation angles for sat a & c. Your toroidal comes with 1 year manufacturer’s li...
