Waves doubler software guide page 1 of 6 waves – doubler software audio processor user’s guide.
Waves doubler software guide page 2 of 6 chapter 1 – introduction and overview the waves doubler is a digital audio effects processor that replicates the incoming audio signal to another 2 or 4 voices. Each voice can be changed in gain, pan, delay and tune (pitch). This achieves a wide range of colo...
Waves doubler software guide page 3 of 6 chapter 2 – controls and displays. The doubler offers a selection of controls and displays as an interface to the dsp algorithm. This chapter lists the different controls and displays and details the properties of each. C ontrols per-voice control strips each...
Waves doubler software guide page 4 of 6 m odulation d epth : –200 to +200 in cents. Default: 0. Positive values will start by modulating upwards, negative values will start off modulating downwards. The modulation will always occur around the voice’s nominal detune so if you set a detune of 10 and ...
Waves doubler software guide page 5 of 6 f requency : low shelf cutoff 16hz to 1600hz. Default: 156hz. Hi shelf 1000hz to 21000hz default: 5990hz. Master controls include: a lign d irect : on/off. Default: off. When set to on, this control delays the direct signal in order to align it to the voices’...
Waves doubler software guide page 6 of 6 master output and meters m aster o utput g ain : 0.0 to –infinity. Default: 0.0db. The master gain control will affect the total doubler output, including the direct path. When there is a generally good-sounding setup that occasionally clips the output, you c...
