Summary of Dynamics Processor MV2
Page 1
Mv2 user manual mv2 user manual 1.
Page 2
Table of contents chapter 1 – introduction ................................................................................................ 3 1.1 welcome.................................................................................................................. 3 1.2 product overview ............
Page 3: Chapter 1 – Introduction
Chapter 1 – introduction 1.1 welcome thank you for choosing waves! In order to get the most out of your waves processor, please take the time to read through this manual. In conjunction, we also suggest that you become familiar with www.Wavesupport.Net . There you will find an extensive answer base ...
Page 4
1.3 concepts and terminology low level compressor low level compression can be explained in simple terms as the opposite of standard or high level compression. In a standard compression setting, any signal above the set threshold gets compressed and attenuated. With the mv2 low level compression fun...
Page 5
1.4 components waveshell technology enables us to split waves processors into smaller plug-ins, which we call components . Having a choice of components for a particular processor gives you the flexibility to choose the configuration best suited to your material. O mono o stereo mv2 user manual 5.
Page 6
Chapter 2 – quickstart guide - use the left fader to set the low level threshold - use the right fader to set the high level threshold - use the middle cut/boost meters to monitor the amount of gain cut and boost - use the output gain fader to trim your output level mv2 user manual 6.
Page 7
Chapter 3 – interface and controls 3.1 interface mv2 user manual 7.
Page 8
3.2 controls low level sets the low level compression threshold. Compression is applied to signals below this threshold. (from bottom up) range : 0 to +48 dbfs high level sets the high level compression threshold. Compression is applied to signals above this threshold. (top down) range : 0 to -48 db...
Page 9: Chapter 4 – The Wavesystem
Chapter 4 – the wavesystem 4.1 the wavesystem toolbar all waves processors feature the wavesystem toolbar which takes care of most administrative functions you will encounter while working with your waves software. The features of the wavesystem toolbar are the same on practically all waves processo...
Page 10
Loading presets and setups click-and-hold on the load button to see the load pop-up menu. The menu is divided into four sections. If a section is not currently available it will not appear in the load pop- up menu. Open preset file… select to open any setup or preset file, whether from the library o...
Page 11
Deleting presets you may delete user presets and presets within a setup file. Factory presets and setup library files cannot be deleted or overwritten. 1. Hold the command (mac)/control (pc) key down. 2. Click-and-hold the load button to see the pop-up menu. 3. While still holding the command/contro...
Page 12
4.3 interface controls controls can be in one of three states: • not selected where the control is not the target of any user entry • selected where the control is the target of mouse control entry only • selected and active where the control is the target for both mouse and keyboard entry toggle bu...
Page 13
Down shift while clicking the mouse on any control you wish to link. This second method is useful when you want to select two (or more) controls that are separated on the gui by other controls you do not wish to select. Tab functions tab moves the ‘selected’ status to the next control, with shift-ta...