Waves GTR User Manual - 4.3 Interface Controls
preset a name. User Presets are stored in the
plug-in’s preference file.
D
ELETING
P
RESETS
You may delete User Presets and presets within a Setup File. Factory Presets
and Setup Library files cannot be deleted or overwritten.
1. Hold the Command (Mac)/Control (PC) key down.
2. Click-and-hold the Load button to see the pop-up menu.
3. While still holding the Command/Control key, select the preset or setup to
delete.
4. A confirmation box will appear, allowing you to cancel or ‘OK’ the deletion.
A/B
C
OMPARISON AND
C
OPYING
The Setup A/Setup B button may be clicked to compare two settings. If you load
a preset in the Setup B position, this will not affect the preset loaded into the
Setup A position, and vice-versa.
If you want to slightly modify the settings in Setup A, you can copy them to Setup
B by clicking on the Copy to B button, then alter Setup A and compare with the
original Setup B.
The name of the current setup will be shown in the title bar (on platforms which
support it), and will switch as you change from Setup A to Setup B.
Note: an asterisk will be added to the preset name when a change is made to the
preset.
4.3 Interface Controls
Controls can be in one of three states:
•
Not Selected
where the control is not the target of any user entry
•
Selected
where the control is the target of mouse control entry only
•
Selected and Active
where the control is the target for both mouse and
keyboard entry
T
OGGLE
B
UTTONS
Toggle buttons display the state of a control, and allow switching between two or
more states.
Single-click
to change the control’s state. Some toggle buttons have
Waves GTR Amp User Guide
18