- DL manuals
- Wavion
- Accessories
- WBS-700
- Installation Manual
Wavion WBS-700 Installation Manual
Summary of WBS-700
Page 1
Wbs-700 mhz outdoor wi-fi base station installation guide rev. 1 september 2010
Page 2
Copyright notice ©2010 wavion, inc. All rights reserved. Wavion is a registered trademark of wavion in the united states and certain other jurisdictions. Specifications are subject to change without notice. Fcc notice to users and operators this equipment has been tested and found to comply with the...
Page 3
3 wavion networks contents chapter 1 about this guide....................................................................... 4 preface .................................................................................................. 4 conventions .......................................................
Page 4: Preface
4 wavion networks chapter 1 about this guide preface this guide details the wavion wbs-700 installation procedures. The intended audience of this document is trained technical professionals. Conventions the exclamation point within a triangle is intended to alert the user to the presence of importan...
Page 5: Contacting Technical Support
Installation guide 5 contacting technical support for technical support, contact wavion using these methods: address: wavion technical support wavion 5 hamada street, po box 580 yoqneam illit, 20692 israel telephone: +972-4-9097343 fax: +972-4-9097322 email: support@wavionnetworks.Com web: www.Wavio...
Page 6
Introduction installation guide 6 chapter 2 introduction wbs-700 a high capacity, ip services oriented broadband wireless access system. Wbs-700 is a new category of broadband wireless base station designed from the ground up for metro-wi-fi deployments. The system employs wireless packet switched d...
Page 7
Package content installation guide 7 chapter 3 package content check that the package contains: qty description 1 wbs-700 outdoor unit with connections to external antennas 6 n-type to n-type rf cables 6 antennas 2 clamps 46-125 x 14 mm stst 1 post clamp 1 safety cable 1 poe injector unit with wall ...
Page 8
8 wavion networks addition tools and materials, including appropriate means (e.G. A pole) for installing the outdoor equipment. 1/4-inch flat blade screwdriver warning : only experienced installation professionals who are familiar with local building and safety codes and, wherever applicable, ar...
Page 9
Installation guide 9 chapter 4 installing the wavion wbs-700 metro base station this guide explains how to safely install the wavion wbs-700 metro base station. The following topics are covered in this chapter: important safety instructions preparing for installation mounting strategies using hose c...
Page 10
10 wavion networks important safety instructions w arning : it is illegal to modify the construction of this product. Modifying the operating frequency or enhancing the transmit output power through the use of external amplifiers or other equipment is specifically disallowed by the "telecommunicatio...
Page 11: Preparing For Installation
Installation guide 11 caution only ul listed parts and components will be used for installation. Use ul listed devices having an environmental rating equal to or better than the enclosure rating to close all unfilled openings. Caution to maintain overvoltage (installation) category ii, install a sui...
Page 12
12 wavion networks choosing a location to ensure the optimal performance select the locations for the equipment using the following guidelines: the antenna (not-integrated on the front panel of the outdoor unit) should provide a direct, or near line of sight, with the sector location that need to ...
Page 13: Mounting Strategies
Installation guide 13 mounting strategies consider the available mounting structures and antenna clearance when choosing a mounting location. Wavion outdoor unit wbs-700 should always be mounted with the top of the unit parallel to the ground, and with the antennas pointing upward and clear of obstr...
Page 14
14 wavion networks there are two pairs of threaded holes on the back of the unit, enabling to use the special clamps for mounting the unit on diverse pole diameters. Figure 4.2 using special hose clamps & screwing the clamps.
Page 15
Installation guide 15 mounting on a pole/streetlight wbs-700 can be mounted on a pole, tower, or streetlight. It is recommended to mount the wbs-700 on aluminum or galvanized steel structures. Note the wavion wbs-700 must be mounted with the top of the unit parallel with the ground and with the ante...
Page 16
16 wavion networks warning : metal pole installation requires that the antennas are higher than the top of the pole. Note antennas must be higher than the top of the metal pole and clear of any obstructions note mounting to wood, concrete, or painted poles requires primary grounding for the unit. Ch...
Page 17
Installation guide 17 5. Attach safety cable to protect installed unit figure 4.5 attached safety cable.
Page 18
18 wavion networks 6. Use a torque wrench click type or digital set to 10 ft-lb, put a layer of loctite 242 type on the screws surface and torque all 4 screws. Re- torque to 15 ft-lb figure 4.6 use a torque wrench click note : the wbs-700 unit must be parallel to the ground. The unit can be rotated ...
Page 19
Installation guide 19 7. Grounding wbs-700. Figure 4.7 grounding method caution : you must always install an external grounding wire. You must also ground the outdoor data protection device to a ground rod or a bonded pipe. Make sure you have completed grounding before you connect power to the wbs-7...
Page 20
20 wavion networks 2. Connect the other end of the grounding cable to a good ground (earth) connection. (for example, a grounding rod). Figure 4.8 grounding grounding the data protection device the grounding method for an indoor data protection device is shown in figure 4.9 . To ground an indoor dat...
Page 21
Installation guide 21 figure 4.10 grounding injector that located outdoor by network protection unit.
Page 22: Connecting Antennas
22 wavion networks connecting antennas this section explains how to connect the six antennas to the wbs-700x. In order for the wbs-700 to work properly, six antennas must be connected. Use 6 rf cables to connect all 6 antennas to the unit body. Each rf cable has two sides with right angle and straig...
Page 23
Installation guide 23 figure 4.12 connecting right angle n-type connector to the antenna figure 4.13 connecting 6 antennas.
Page 24
24 wavion networks w arning : only connect the unit to the power supply once all the antennas are connected. W arning : use caution when connecting the antennas. Undue haste can damage the unit. W arning : do not screw in the antenna when holding the top section of the antenna. You will most likely ...
Page 25: Antenna Sealing
Installation guide 25 antenna sealing the following describes antenna sealing procedure caution : it is important to read carefully this procedure and perform all its steps to ensure maximal moisture protection. Sealing technique: after the antenna is connected, use isolation material to cover the n...
Page 26: Connecting Power and Data
26 wavion networks connecting power and data the following describes how to apply power and data to the wbs-700 caution : you must always install an external grounding wire. Perform a simple continuity check between the wbs-700and the ground termination point to confirm. You must also ground the out...
Page 27
Installation guide 27 when connecting to the ethernet port, if you need to terminate the ethernet cable, use a standard rj45 termination. Use a shielded rj45 plug and be sure to connect the shield of the ethernet cable to the shield of the rj 45 plug. To connect to the data port: 1. Make sure that t...
Page 28
28 wavion networks step 1 step 2 step 1 and step 2: unscrew the plastic cap and the cap cover. Thread the ethernet cable through the cap cover and the cap. Connect the ethernet cable to the “eth” port. Step 3 step 4 step 3 and step 4: screw the plastic cap; make sure it is well tightening. Furthermo...
Page 29
Installation guide 29 poe port rj45 pin descriptions pin t/r signal color description 1 t txd+ orange-white tx data 10/100baset 2 r txd- orange tx data 10/100baset 3 t rxd+ green-white rx data 10/100baset 4 r poe+ blue power input, 55 vdc (+) 5 t poe+ blue-white power input, 55 vdc (+) 6 r rxd- gree...
Page 30: Service Instructions
30 wavion networks safety information for the wavion wbs-700 the federal communications commission (fcc) with its action in et docket 96-8 has adopted a safety standard for human exposure to rf electromagnetic energy emitted by fcc certified equipment. Proper operation of the wavion wbs-700according...
Page 31
Installation guide 31 chapter 5 product specification wbs-700 the tables in this chapter contain specifications for the wavion wbs-700. Physical specifications network interfaces auto-sensing 10/100 ethernet input from wavion injector power input power from a wavion poe injector. Indicator lig...
Page 32
32 wavion networks environmental specifications operating temperature range -40°c to +55°c (without sun shield) -40°c to +60°c (with sun shield) storage temperature range -45°c to +85°c weather rating ip67 wind survivability 165 mph salt and fog rust resistance mil-std-810f 509.4 shock and vibration...
Page 33
Installation guide 33 chapter 6 installation accessories this chapter describes the accessories available for the wbs-700 and ordering information. The following topics are covered in this chapter: ethernet cables lightning protection power over ethernet ethernet cables description manufacturer part...
Page 34
34 wavion networks chapter 7 wind loading considerations this chapter describes wind loading considerations for the wbs-700. Note: it is recommended to evaluate the static and dynamic load bearing capabilities for each assembly and installation individually. It is your responsibility to evaluate the...
Page 35
Installation guide 35 chapter 8 acronyms acronym description 2p two-phase or split phase 2w two-wire 3w three-wire ac alternating current ansi american national standards institute awg american wire gauge c celsius cat category cck complementary code keying cfr code of federal regulations csa canadi...
Page 36
36 wavion networks mhz megahertz mil-std military standard n neutral nec national electrical codes nema national electrical manufacturers association ofdm orthogonal frequency division multiplexing p phase pe protective earth poe power over ethernet rj45 registered jack 45 rss received signal streng...