Waxman LeakSmart 8810200 Installation And Operating Manual

Manual is about: Leak Detection & Automatic Water Shut-off System

Summary of LeakSmart 8810200

  • Page 1

    Leak detection & automatic water shut-off system water heater kit - 8810200 installation and operating manual leaksmart by waxman ™ © 2014 waxman consumer products leak smart ™.

  • Page 2

    Leaksmart water heater kit leaksmart water heater kit 3. Water heater kit - model 8810200 features: • electronic led control panel has easy to read and use lighted function buttons • ac power with battery back-up – for continued operation in the event of power outages • lead free compliant, full - p...

  • Page 3

    Preparation step 4 instructs you to install the leaksmart valve (3/4” fip x 3/4” mip) between the rigid water line coming off the manual cold water valve and the water heater. Most rigid lines will be copper. Evaluate your line and determine which size adapter fitting you will need (the most common ...

  • Page 4

    6. 7. Leaksmart water heater kit leaksmart water heater kit installation instructions: 1. Shut off main water supply valve. 2. Open faucet nearest water heater to relieve water pressure. 1. 2. 3. If you have a manual water shut-off valve on the cold water line that supplies water to the water heater...

  • Page 5

    8. 9. Leaksmart water heater kit leaksmart water heater kit 5. Mount the leaksmart control panel in an easily accessible location within 30 inches of the leaksmart valve. You may mount the panel using the screws and anchors or hook & loop mounting pad provided. When using the hook & loop mounting pa...

  • Page 6

    10. 11. Leaksmart water heater kit leaksmart water heater kit installation instructions installation instructions 9. 10. 9. Plug the pin on the end of the ac power adaptor cord into the bottom of the control panel, and then plug the ac power adaptor into the nearest 110 volt wall outlet. Green indic...

  • Page 7

    12. 13. Leaksmart water heater kit leaksmart water heater kit how to operate your control panel 1. Top button opens leaksmart valve 2. Middle button closes leaksmart valve 3. Bottom button mutes the audible alarm that sounds when a leak is detected 1 2 3 testing your leaksmart system 1. Push the ope...

  • Page 8

    14. 15. Leaksmart water heater kit leaksmart water heater kit troubleshooting problem what to check status light does not light - make sure there is power to the outlet. - unplug ac power adaptor cord from control panel and plug back in. - if an ac power adaptor extension wire was used, unplug both ...

  • Page 9

    16. Leaksmart water heater kit leaksmart water heater kit problem what to check leak sensor becomes wet but leaksmart valve - locate plug connection between control does not close (continued) panel and leaksmart valve. Unplug the connection and reconnect, making sure arrows on the side of plugs line...

  • Page 10: Leak

    18. 19. Leaksmart water heater kit 2 year limited warranty waxman consumer products group warrants the enclosed leaksmart product to be free from defects in materials or workmanship, under normal use and service, for a period of two (2) years from the date of purchase. If at any time during the warr...

  • Page 11: Leak

    21. Sistema de cierre automático y detección de pérdidas de agua kit de calentador – modelo 8810200 ® 2014 waxman consumer products manual de instalación y funcionamiento leaksmart de waxman ™ leak smart ™.

  • Page 12

    23. Leaksmart de waxman ™ felicitaciones por la compra de un kit de detección de fugas en el calentador de agua de leaksmart de waxman™. Leaksmart es un sistema patentado electrónico de detección de fugas y corte automático de agua para fugas causadas por un calentador de agua. Este producto fue dis...

  • Page 13

    24. 25. Preparación: el paso 4 le enseña a instalar la válvula leaksmart (3/4” fip x 3/4” mip) entre la línea rígida de agua que sale de la válvula manual de agua fría y el calentador de agua. La mayoría de las líneas rígidas serán de cobre. Evalúe su línea y determine el tamaño del conector que nec...

  • Page 14

    26. 27. Continúa en la página siguiente 1. Cierre la válvula principal de suministro de agua. 2. Abra el grifo más cercano al calentador de agua para liberar la presión de agua. 1. 2. 3. Si usted tiene un agua de la válvula de cierre manual en la línea de agua fría que suministra agua al calentador ...

  • Page 15

    28. 29. Continúa en la página siguiente 5. Monte el panel de control leaksmart en un lugar de fácil acceso a menos de 76,2 cm (30 pulgadas) de la válvula leaksmart. Puede montar el panel usando los tornillos o la almohadilla de montaje autoadherible proporcionada. Cuando use una almoh adilla de mont...

  • Page 16

    9. Conecte el pin en el extremo del cable adaptador de alimentación de ca en la parte inferior del panel de control y, a continuación, conecte el adaptador de alimentación de ca a la toma de corriente de 110 voltios más cercano. Las luces indicadoras verdes comenzarán a parpadear indicando que tiene...

  • Page 17

    • la prueba de agua se puede hacer con la funda de papel todavía puesta en el detector de fugas. Tenga en cuenta que la funda de papel es reusable, pero una vez que se moja, necesitará secarla antes de volver a colocarla en el detector de fugas. Cómo hacer funcionar el panel de control 1. El botón s...

  • Page 18

    34. 35. Solución de problemas problema qué hay que verificar la luz de estado no enciende. - asegúrese de que haya energía en el tomacorriente. - desenchufe el cable del adaptador de alimentación de ca del panel de control y vuelva a enchufarlo. - si empleó un cable de extensión para el adaptador de...

  • Page 19

    36. 37. Problema qué hay que verificar el detector de fugas está mojado pero la válvula - ubique la conexión del enchufe entre el panel de control y la válvula leaksmart. Desenchufe la conexión y vuelva a conectarla, asegurándose de que las flechas al costado de los enchufes estén alineadas. - si em...

  • Page 20

    38. 39. Kit de calentador leaksmart kit de calentador leaksmart garantía limitada de dos (2) años waxman consumer products group garantiza que los productos incluidos leaksmart no presentarán defectos en el material o en la mano de obra, bajo uso y mantenimiento normales, durante un periodo de dos (...

  • Page 21: Leak

    This product is covered by the following patents: u.S. Patent nos. 6,369,714 & 7,549,435 este producto está cubierto por la siguientes patentes: u.S. Patent nos. 6,369,714 & 7,549,435 ©2014 waxman consumer products 24455 aurora road bedford heights, ohio 44146 designed in the u.S.A. Made in china di...