Waxman LeakSmart Water Valve Installation & Operation Manual - Leaksmart
6
leakSMART
™
Valve Setup and Operation
1.
Pair your leakSMART
™
valve with your smart home system
•
Place your leakSMART
™
Valve near your installation location,
so you can verify that it is within range of your smart home
leakSMART
™
Hub. Verification will be done in pairing mode in
APP.
•
Connect leakSMART
™
Valve to the provided 9V Power
Supply and verify that the AC power cord is long enough
to reach the valve installation location. (An optional 9 ft.
AC power adapter extension wire is also available. This,
and other leakSMART
™
accessories, can be purchased at
getleakSMART
™
.com) It is recommended to install 4 AA
alkaline batteries (not provided) as a source of battery
backup. ( A flashing blue light on the front of the unit will
indicate that it’s ready to pair. If the blue light stops flashing,
press the center button quickly 5 times to reset pairing
mode).
Now, open the leakSMART
™
App on your smart device.
On the leakSMART
™
Hub, briefly press the blue button
once to enter into pairing mode. As a reminder, a steady
green flashing light on the leakSMART
™
Hub indicates
pairing mode and will last 3 minutes while in pairing
mode.
CAUTION: Read installation instructions BEFORE installing batteries in your leakSMART
™
Valve or Sensors.